Lapcom s series Instruction Manual - page 6
7. Confirm the following parameter setting to log the driving data properly. Press
and hold the CLEAR key for 3 seconds to exit the setting.
Parameter No. 3: Number of Segments
Parameter No. 4: Sensor Off Timer
Parameter No. 5: Speed Pulse Length
Parameter No. 7: Logging start/stop condition
* Please refer to each model’s instruction manual for the parameter
setting.
* It is necessary to measure speed.
8. Insert a SD card into the Lapcom main unit, and confirm the SD card mark is
shown on the display.
LED and Display indication
LED and the display indication of each status are as follows;
Acquiring GPS satellite
Completed GPS satellite acquisition
POWER (Blue)
illuminate
STATUS (Red)
flash
POWER (Blue)
illuminate
STATUS (Red)
illuminate
GPS or DGPS
illuminate
- 5 -