Larius 2 Operating And Maintenance Instructions Manual - Troubleshooting

11

LARIUS 2 - painting

English

J

TROUBLESHOOTING

Solution

Cause

Problem

• 

The equipment does not suck the 

product

• 

The equipment suck but does not 

reach the pressure desired

• 

When  pressing  the  trigger,  the 

pressure lowers considerably

• 

The  pressure  is  normal  but  the 

product is not atomized.

•

Leakage from the seal-tightening 

screw

• 

The atomization is imperfect

• 

Suction filter clogged;

• 

Suction filter too fine;

• 

The equipment sucks air;

• 

Lack of product;

• 

The equipment sucks air;

• 

The circulation tap is open;

• 

Nozzle too big or worn;

• 

The product is too dense;

• 

The nozzle is partially clogged;

• 

There is no atomising air;

• 

The product is too dense;

• 

Gasket worn or needs adjustment;

• 

The nozzle is worn;

• 

Clean or replace it;

• 

Replace it with a larger-mesh filter 

(with very dense products, remove 

the filter);

• 

Check the suction pipe;

• 

Add the product;

• 

Check the suction pipe;

• 

Close the circulation tap;

• 

Replace it with a smaller one;

• 

Dilute the product, if possible;

• 

Clean or replace it;

• 

Check  the  flow  regulator  for  the 

atomising air;

• 

Dilute the product, if possible;

• 

Replace or adjust the gasket;

• 

Replace it;