Laser AO-DIGICAM08 User Manual - Getting Started
AO-DIGICAM08
USER MANUAL
4
Getting Started
Prior to using the AO-DIGICAM08 you will need to fit 2 X AAA battery (Not supplied) in to
the compartment on the underside of the camera.
Please ensure that the compartment lid is secured correctly.
The AO-DIGICAM08 can be connected and be used by the PC with batteries being fitted.
Warning: The AO-DIGICAM08 memory is erased when not connected to a USB power or the batteries are
removed. Please download all picture or videos stored on the camera to the PC before opening the battery
compartment.
Tip: The Batteries can be changed by connecting the AO-DIGICAM08 to a powered USB port or USB charger
before opening the battery compartment. Leave the USB cable connected until new batteries are fitted and
the compartment is secured.
Taking Photos
1. Press the Power Button to start the camera.
2. Check the number of remaining shots and current
resolution on the main display (as per right)*.
*Please see further for more details
3. Change the capture mode if required.
4. Look through the viewfinder on the rear of the camera and place the subject in the
centre of the viewfinder.
5. Hold the camera steady and press the Shutter button. A beep will sound when the
picture has been taken.
6. The LCD will show 0 when no more pictures can be taken.
7. Press and Hold the Power Button until a beep is heard. Release the button and the
camera will turn off.
8. In Hi resolution it may take up to 2 seconds before the next shot can be taken.
Tip: for best results stand between the available light source and the subject where
possible. The quality of the light will affect the quality of the picture.