LaserShield Instant Security System Quick Start Manual - Test System
TEST SYSTEM
EXIT LEARN MODE
LEARN & LINK DEVICES
4
5
6
• Press Learn button on rear of MAU
• MAU will announce an inventory of the devices successfully learned into the system
(If fewer than one keychain remote AND one WDU are learned
into to the system the MAU will announce "System
Disabled". Return to step 4 to learn the
missing keychain remotes or WDUs)
NOTE:
Be certain all devices are
acknowledged by the MAU.
Press Button
to Exit
Learn Mode
You must link your Keychain Remotes and WDU's to the MAU for the system to work:
1. Press Learn button on rear of MAU
2. One keychain remote at a time, press the ARM and DISARM buttons together
(MAU announces "Keychain number X stored in memory")
3. Press the red Panic button on each Wireless Detection Unit
(MAU announces "Satellite number X stored in memory")
Press Learn
Button
Press
Panic
Button
Press Both Buttons Together
Press Button
to Disarm
NOTE:
Pressing Panic button on MAU during Learn Mode will erase all devices.
Master Alarm Unit (MAU)
Wireless Detection Unit
(WDU)
1
2
3
1. Press a Panic button
Let the siren sound for about 10 seconds
2. Disarm system with Keychain Remote
3. Have your 5 digit passcode handy
(you'll find this passcode on the
wallet cards inside the document package included with your Lasershield)
4. Answer the phone call from Rapid Response Monitoring that you'll receive on your
premises telephone in approximately 30 seconds
5. Respond to the voice prompts using your telephone keypad
6. When this test is successful the voice on the phone will announce that your account is activated
1
2
Press Panic
Button to Test