Laspaziale S1 Dream-T Owner's Manual - Features
S1 Dream-T Espresso Machine
Owner’s Manual
Page 7
Features
User Profiles
The S1 Dream-T is capable of storing 4 different user profiles. This enables the machine to be
programmed for different shot volumes, brew temperature, steam boiler water temperature,
and hot water delivery method. The machine can easily be switched between different user
profiles to meet the discriminating demands of everyone that uses it. Profiles can also be used
for different coffee blends that require different temperatures so use your imagination and the
possibilities are endless.
Creating User Profiles
To create a user profile the machine should be turned on and up to temperature. To access
the menu press and hold the button for approximately 3 seconds until the menu appears on
the display. Then use the down arrow key to cycle through the menu until the display reads
PROGRAM
and then press the button to enter the program menu.
Once in the program menu you can use the arrow key to cycle through the user profiles.
USER1
will be the default user and should be programmed first. Press the button to select
and program
USER1
. Once in the
USER1
profile you can cycle through the various options
available for programming and then press the button to select that option to change. The
following parameters can be changed in the user profiles menu.
Coffee Temperature
Use the arrow keys to select the desired brew temperature and then
press the button to save the setting. The recommended brew temperature is between 200-
204°F, but can be easily changed to match the coffee you are using. Experiment until you find
the temperature your coffee tastes best at.
Boiler Temperature
Use the arrow keys to select the desired steam boiler temperature and
then press the button to save the setting. The recommended steam boiler temperature is
between 250-260°F. Going too low in temperature may cause a loss of steam pressure.
Coffee Doses
To program the coffee doses fresh coffee must be prepared for each button that
is programmed and the machine should be up to temperature. To program a coffee dose,
prepare and tamp the coffee and lock the portafilter into the grouphead. Whichever portafilter
you have in the grouphead press the corresponding
/
button to start the programming.
When the shot has reached the desired level then press the same
/
button again to
stop the shot and save the new setting. Repeat the above step to program the other shot
button. The recommended size for a single shot is 1oz and 2oz for a double shot, but can be
fine tuned to your particular tastes.