Lassco Wizer Spinnit EBM-S User Manual - page 7
Setting Up Your Machine
Back Gauge Assembly
Stop Collars and Paper Side Stop
Page 05
Attach the Backguage (EBMS-115A) to the Table by hooking
the left end over the Side Iron (FM4-4003) on the side as
shown in the accompanying pictures. Align both ends of the
backgauge using the Table Scales so that it is squared
correctly. When it is positioned as desired, tighten down the
Backguage Clamp (EBMS-10) as shown.
For multi hole drilling, adjust the Stop Collars (EBM-47) by
loosening them with the provided Hex Wrench (HEX-332).
Slide the Stop Collars (EBM-47) to the desired positions and
tighten. Slide the Paper Side Stop (EBMS-8001) against the
Stop Collars to brace it in place. When its time to drill slide
the product up against the Paper Side Stop and hold in
place.
Step #1
Step #2
To slide the Paper Side Stop to the next Stop Collar, lift up on
the Paper Side Stop releasing the bracing pin from hitting the
Stop Collar as shown. Slide the Paper Side Stop past the
Stop Collar and set it down so that it braces against the next
Stop Collar.
Step #3
Note:
Do not position the Backgauge too close to the hollow drill bit so
that it touches. This can cause serious damage to the hollow drill
bit causing it to break or shatter. The Backgauge must be at least
1/8” from the circumference of the hollow drill bit.