Lathem PC700 User Manual - Network Setup - Wifi
Using the PC700 Series Clock
• 25
• The Administrator Main Menu screen will display.
• Press Network Setup. The Network Setup screen will
display.
• If you want to set the clock’s IP address as a “Static” IP turn
off DHCP by pressing the OFF button. The screen will
refresh and more buttons will become active.
• Press the IP Address button. The IP Address screen will
display.
• Using the numeric key pad enter the IP address you want to
assign to the clock and press OK.
• Press the Subnet Mask button. The Subnet Mask screen will
display.
• Using the numeric key pad enter the address you want to
assign to the clock and press OK.
• Press the Gateway button. The Default Gateway screen will
display.
• Using the numeric key pad enter the address you want to
assign to the clock and press OK.
• When finished press the back button until you have
returned to the default screen.
Network Setup - WiFi
This option is used to select and connect to a WiFi access point.
• From the PC700 touchpad press the Admin button. Enter the
administrator password and press Enter.
• The Administrator Main Menu screen will display.
• Press Network Setup. The Network Setup screen will
display.
• Press WiFi. The PC700 will check to see if there are any Wi-
Fi connections within range and display them in a list. Note:
Make sure the WiFi Enabled is set to Yes.
• Select the desired Wi-Fi connection from the list.
• The Enter Passcode screen will display with a keypad.
• Using the master buttons to select upper case letters, lower
case letters, numbers or symbols enter the passcode for the