Latte LP-15 Operating Instructions Manual - page 5
34
6
7
5
Programming the fill up level / default time
Heating (default time 30 sec. / 150 ml hot milk)
Energy saving mode
•
After 5 minutes of NON using the appliance, the appliance will automatically switch into energy-saving mode.
The buttons will light up alternately.
•
By pressing either one of the buttons, the appliance will resume in normal function mode.
•
The energy-saving mode time can be changed from 5 minutes (factory default time) to 30 minutes.
-
For 5 minutes setting: press and hold button A and switch on power untill all buttons light up.
-
For 30 minutes setting: press and hold button B and switch on power untill all buttons light up.
Frothing (default time 20 sec. / 100 ml foam & milk)
4.3 Reset to factory settings
Press A for approx.
3 seconds until it flashes
Press B for approx.
3 seconds until it flashes
Press both buttons
simultaneously for
3 seconds
Press A again to set
the cup volume
Press B again to set
the cup volume
Setting range cup
volume 5 - 60 seconds
Setting range cup
volume 5 - 60 seconds
5 sec
60 sec
5 sec
60 sec
Start
Stop
Stop
Start
Cleaning the appliance
Before starting the cleaning process
Protection function
•
The CLEAN button will flash fast when the front cover or the milktank will be removed from the appliance.
This appliance has two cleaning programs: short clean & long clean
The application is as follows:
Fill water tank with fresh
water (max. 600 ml)
Press the button once for
a short program
(30 seconds)
Take out the milktank and
place cleaning cup
Hold the button for
> 2 sec. to start a long
program (60 seconds)
Fill the milktank with
water for thorough
cleaning (min. 200 ml /
max. 600 ml)
30 sec
60 sec
Long clean x2
Short clean
• Before the first use
• After long periode of non-use
• When appliance not in use
• At the end of the day after use
• Before the first use every day
• Between each cups if there is an interval time of more
than 30 minutes.
NOTE
• It is recommended to clean the front cover and
the froth head in water after the LONG CLEAN
program, for hygenic purposes. The milk tank
and suction pipe must be cleaned after use.
It is recommended to immerse them in warm wa-
ter overnight.
Cleaning the outside of the appliance
•
Remove the plug from the outlet before cleaning the appliance.
•
Wipe outside with a soft, dry cloth, after the appliance is cooled down. Never use metal polish!
•
The removable items are NOT dishwasher safe