Latte LP-15 Operating Instructions Manual - page 6
6
7
9
11
10
8
Descaling
NOTE
• Run decalcification every 3 months or after 300 cycles.
• Start the decalcification program only when the appliance is cold (Appliance will not start if its hot)
Preparation
Switch of the appliance
and remove all accesoiries
Fill water tank and add
descaler to recommended
ratio on box
Place large glass or
container underneath
the milkoutlet
Decalcification
Hold down the clean but-
ton and switch on power
untill all buttons light up
Switch appliance off,
remove water tank and
froth head
When CLEAN button
lights up the appliance
is ready for decal cycle.
Press CLEAN button
Clean the water tank
and froth head under
tap water
Clean and refill water
tank* (keep appliance
switched on)
Attach froth head
and cleaning cup and
switch appliance on
Press CLEAN button
for 5 min. run with tap
water. Run 2 times
Run the ‘Long clean‘
program at least 2
times. After this the ap-
pliance is ready for use
NOTE
• * Make sure there is no descaler left in water tank
2x 5 min.
2x 60 sec.
Troubleshooting
Faults
Possible cause
Repairs
Indicator lights do not flash after
switching on the appliance
Plug not in socket or power cord
connector
Connect plug
No milk flow
• Water tank empty
• Front cover not attached properly
• Suction pipe from milk tank lid
not assembled
• Fill water tank
• Attach front cover
• Connect suction pipe to lid from
milk tank
Button B flash fast
• The appliance is overheated
• Switch appliance off untill it is
cooled down. Then switch on
again. If button B still flashes fast
contact service center.
Button A flash fast
• Environment is too cold.
Less than 5 degree °C
• Place the appliance to room temp
environment. If button A still fla-
shes fast contact service center.
NOTE
• If you cannot solve the problem following the steps outlined above, please contact the customer service.
Technical data
Dimensions (H x B)
254 x 361
mm
Approx. weight
3,3
kg
Operating voltage
220-240
V
Frequency
50 - 60
Hz
Power consumption, max.
1000
W
Length of cable
1,5
m
Watertank
600
ml
Milktank
600
ml
Storage / Disposal
If you do not need the appliance for an extended period of time, allow it to cool down and clean the appliance
as described in the chapter Cleaning and Care to prevent mould formation. Mould fungus represents a health
risk and stains may develop on the unit which can no longer be removed. Electric and electronic end-of-life
appliances often still contain valuable materials. However, they also contain hazardous substances which
were required for their proper function and safety. If disposed of with regular household waste or treated
incorrectly they can pose a risk to human health and the environment.
NOTE
• Use the collecting station in your municipality to return electrical and electronic end-of-life appliance for
recycling. Obtain the information required, if necessary, from your city hall, your waste disposal company
or your dealer.
• Render the appliance unusable before disposal. Make sure your end of life appliance is stored safely away
from children until hauled away.