Laundrylux EHWF09810M Installation Manual - page 26
8:1 Installation .
OPL MODE SETUP
To convert the machine for OPL operation, the front control / display module must be
reset to “coin mode” and the prices of all six cycles and options must be set to $0.00.
Fig 1
Reset Control / Display Module
Method A
1. Remove top cover of machine. (Secured with two T15H security Torx fasteners).
2. Locate small “red” reset button behind the left digit in the display. Press and hold
down button.
3. After several seconds the control module will chime and the 4 segment display will
show 0.25. The washer is now in coin mode.
Method B
1. Partially pull out detergent dispenser drawer.
2. Depress and unlock tab in the top back of the drawer with a screw driver, remove
dispenser.
3. Remove the two large Phillips head screws that secure the display controller to the
machine.
4. Slide display module to the left and pull forward, being careful not to damage the
cables coming out of the back of the controller.
5. Reset module as above.
6. Replace and re-secure control / display module using original mounting screws.
Remount detergent dispenser drawer.
Fig 1. Diagram showing reset button on back of the Display CPU. To be created.
Fig 2 Set Program and Options Pricing
Set all six programs and options to 0.00
1. With top cover off, press and release the black service mode plunger switch behind the
card-reader mounting plate. The display will go blank. Alternatively, with the top cover
left on, the service mode switch can be activated using a screw driver inserted in the card
slot in the front of the machine.
2. Press COLD. Program price is displayed.
3. Press START. The current price blinks, indicating it is available for editing.