LavorPro HK070F-A Operation Manual - 0Dlqwhqdqfh
© 2013, Lavorwash
11
Oil Fired Radiant Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED WHILE
BURNING, CONNECTED TO A POWER SOURCE
OR WHILE CONNECTED TO A FUEL SOURCE.
© 2013, BE Pressure Supply Pty Ltd
Kerosene Forced Air Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED
WHILE BURNING, CONNECTED TO A
POWER SOURCE OR WHILE
CONNECTED TO A FUEL SOURCE.
0DLQWHQDQFH
6HUYLFH&RQWLQXHG
FAN BLADES:
Blades should be cleaned at least once per
heating season, depending on conditions.
Remove all accumulated dust and dirt with a
damp cloth, taking care not to bend any of the
fan blades. Be sure the blades are dry before
re-starting the heater. For fan assembly removal
see Figure 14.
FUEL FILTER:
The fuel filter should be cleaned at least twice
per heating season. Clean the filter by rinsing
it in clean 1-K Kerosene. Contaminated fuel
could make cleaning the fuel filter necessary
immediately.
127(7RUHPRYHWKHILOWHUIURPPRGHO
+.)$WXUQILOWHUFORFNZLVH7R
UHPRYHWKHILOWHUIURPPRGHOV+.):$
+.):$+.):$WXUQILOWHU
FRXQWHUFORFNZLVH6HH)LJXUH
SPARK PLUG:
Clean and re-gap every 600 hours of operation, or
replace as needed. After removing the spark plug,
clean the terminals with a wire brush. Re-gap the
WHUPLQDOVWR´PP6HH)LJXUH
PHOTOCELL:
The photocell should be cleaned using a cotton
swab dipped in alcohol or water at least once
per heating season, or more depending on
conditions. See Figure 17.
Figure 14
Fan Blade
Motor Shaft
Set Screw
Figure 15
Fuel Filter
Fuel Line
Side Cover
Figure 16
Ignitor Wire
Spark Plug
Gap
Burner Head
X
X
Figure 17
Photocell
Photocell lens
Photocell Wire
10