LavorPro HK070F-A Operation Manual - 2Shudwlrq
© 2013, Lavorwash
9
Oil Fired Radiant Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED WHILE
BURNING, CONNECTED TO A POWER SOURCE
OR WHILE CONNECTED TO A FUEL SOURCE.
© 2013, BE Pressure Supply Pty Ltd
Kerosene Forced Air Heater User’s Manual
NEVER LEAVE HEATER UNATTENDED
WHILE BURNING, CONNECTED TO A
POWER SOURCE OR WHILE
CONNECTED TO A FUEL SOURCE.
2SHUDWLRQ
6WDUWLQJWKH+HDWHU,JQLWLRQ
1. Fill the tank with kerosene or other approved
fuel until needle on fuel gauge points to “F”.
2. Replace fuel cap and tighten firmly.
Connect the heater to a three prong
(grounded) power source. You must use a
three prong (grounded) extension cord that is
at least 1.8 meters long and is a minimum of
14 AWG rating.
4. Turn thermostat control knob to desired
temperature setting. The thermostat set range
LVIURP&WR&
5. Move power switch to “On” position. The
power indicator light and room temperature
display will illuminate and heater will ignite.
(See Figure 10)
127(,ILIWKHKHDWHUVWLOOGRHVQRWLJQLWHUHIHUWR
³7URXEOHVKRRWLQJ*XLGH´RQSDJH
127(7KH+.)$GRHVQRWKDYH
DURRPWHPSHUDWXUHGLVSOD\IHDWXUH
The room temperature display will indicate the
following:
- When the temperature is less than -17.8 ºC the
display says “LO”.
:KHQWKHWHPSHUDWXUHLVPRUHWKDW&WKH
display says “HI”.
- Between -17.8
°
&DQG
°
C the display shows
actual temperature.
6WRSSLQJ5HVWDUWLQJ+HDWHU
- To stop the heater, move the power switch to the
“Off” position and unplug the power cord.
- To restart the heater; wait 10 seconds and follow
ignition steps.
Figure 9
Power Switch
Power Switch
Thermostat Knob
Temperature Display
Figure 10
8
TIP: If the heater does not ignite, the
thermostat may be set too low. Turn
the control knob to a higher setting until the
heater ignites. If the heater does not ignite;
move switch to “Off” position, check steps 1-3
above and then move switch to “On” position.