Lavry AD11 Manual - page 11
AD11
Operation
7
MODEL AD11
The LavryBlack AD11 features:
-
Built in Microphone preamps with phantom power
-
Accepts +4 or -10 line level inputs balanced or unbalanced
(MicPre’s are relay bypassed)
-
Front panel adjustable gain for each channel
-
0 to 12 dB of gain for line level inputs in precise 1 dB steps
-
20 to 65 dB of gain for low impedance balanced microphone inputs in 1 dB steps
-
Recording at 44.1, 48, 88.2 or 96 kHz with 24 bit word length
-
Super-stable internal clock
-
External clocking via Word Clock or AES/SPDIF sync
-
BNC Word Clock output for synchronizing other gear to the AD11
-
Digital output format selectable between AES/EBU and SPDIF (IEC 60958 type II)
-
Peak hold selectable on large wide range LED meters
-
Soft Saturation for
“hotter” level and peak level control without time constants
-
Optional Rack Mount Kit (can be used to mount any combination of two LavryBlack units)
CONNECTIONS
Connect analog audio INPUTS from your source using any of the following:
-
Professional line level “+4dBu” balanced or unbalanced sources to the XLR inputs
-
Consumer line level “-10dBV” balanced (TRS) or unbalanced (TS) to ¼” inputs
- Low impedance balanced sources (typically microphones) to the XLR inputs for gains >12dBs.
Phantom power is selectable individually for each channel via the front panel.
Stereo digital audio outputs are in the form of XLR, RCA, and USB:
- The XLR and RCA digital audio output connectors can transmit either AES/EBU professional format
or IEC 60958 type II consumer format
(“SPDIF”).
- If more than one digital audio output is needed, a simple XLR to RCA adapter can be used to feed
most coaxial SPDIF inputs from the XLR output, and similarly, a simple RCA to XLR adapter or
adapter cable can be used to feed most AES inputs from the RCA output.
- Connect an external TTL level Word Clock, AES sync, or SPDIF sync to the
clock in
BNC
connector for external clock operation. The input has 75 Ohm termination.
- Connect the BNC
clock out
to another device
’s Word Clock input to synchronize it to the AD11
operating on Internal Clock. The receiving device must have 75 Ohm termination.