Lavry DA10 User Manual - page 12
LavryBlack DA10
Specifications
9
SPECIFICATIONS:
THD+N at max volume (volume = 56) – typical, 0.0008% FS, maximum 0.0013% FS
Test conditions: 20Hz – 20KHz, -3dBFS sine wave, 22-22KHz BW
At all possible settings and switch combinations.
Dynamic Range: -110dB typical, -109 dB minimum
Test conditions: Non weighted
At all possible settings and switch combinations.
Drive Capability:
24dBu Balanced XLR output into 1K ohms at Volume = 56 or lower
21dBu Balanced XLR output into 600 ohms at Volume = 53 or lower
18dBu Unbalanced XLR output into 600 ohms at Volume = 56 or lower
18dBu Headphone into 100 ohms at Volume = 56 or lower
18dBu Headphone into 50 ohms at Volume = 50 or lower
Volume Control Precision:
Integral linearity (deviation from straight line) – better than 0.1dB
Differential linearity (step size) – better than 0.08dB
AC Power:
Voltage 90-264 VAC, Frequency 40-63Hz, Current 0.1A
Fuse Rating 2.5A “Time Delay” *
*Subject to change! Please always check the rating on the fuse and the one printed next to the
fuse holder on the power supply PC board before replacement. Replace the fuse ONLY with a
fuse of the same rating. If you have any questions, contact:
techsupport@lavryengineering.com
Please Note: The DA10 automatically adjusts to AC power inputs in the range of 90 to 264 Volts
AC and line frequencies between 47 and 63 Hertz. There are no settings to change.
Weight and Dimensions:
8” wide x 1.75” high x 10.75” deep (with space for front panel switches and rear panel
connectors),