Lavry DA11 Manual - page 9
DA11
Quickstart Guide
5
Diagram 1, Section 3- Volume Control (Operating mode)
This section consists of the VOLUM
E display and the “up/down” switch.
- The up/down switch always controls the volume in both Operating and Setting modes.
- Please see
the section titled “Determining the Correct DA11 Volume Setting for Your System”
for important information when connecting the DA11outputs to other equipment.
In Operating mode the VOLUME display has two types of indication:
- It displays the volume setting during adjustment via the front panel up/down switch, after IR
remote commands are received, and for approximately 10 seconds thereafter.
-
It displays “LE” at other times in Operating mode to indicate that the settings have been
stored in memory, and that the infrared remote functions have been “gated off” to prevent
accidental changes to the settings (if the gating function is enabled-see below).
Optional Infrared Remote-
The DA11 is programmed to accept standard Philips RC5 TV infrared remote commands. This
means almost any Universal infrared remote control can be programmed to control the DA11.
Be sure to check the pa
ckage of the universal remote to confirm it works with Philips TV’s.
Follow the instructions that come with the universal remote, and program the remote using the
code in the instructions for a Philips TV. If the first code does not work correctly, there is often
more than one code available; so try a different code that is also for a Philips TV.
- Please note: If SAFE MODE is enabled, you must
press and hold “0” on the remote until the
“LE” symbol changes to the numeric Volume display before the DA11 will respond to any
remote functions other than Mute. Toggling the Mute function will confirm that the remote is
programmed properly. The IMAGE LED’s go dark when MUTE is “On.”
- This
“gating function” is called the SAFE MODE and is “disabled” by factory default. Please
see the OPTIONAL INFRARED REMOTE section of the manual for more details.