Lawnbott L50BEU Installation Course - page 15
- 20 -
Revision and Winter Service
Revision for updating the robot
Each time the robot is repaired, it is recommended to:
-
Update the robot version using the robot programmer.
-
Check the impedance (OHM) of the recharging knobs and the cable.
It must be lower than 1-2 Ohm. Maybe we must install a contact
spring (050Z04400A)
as indicated in the picture
.
-
Check the condition of the batteries.
-
Check that the screws of the blade are well secured. And the screws
fastening the motor.
-
Clean the recharging knobs with sandpaper.
-
Clean and sharpen the blade.
-
Check that the seal gaskets are secure.
Operations during winter storage
-
Check/Replace the brushes of the blade motor.
-
Check/Replace the brushes of the wheel motor.
-
Test the wear and tear of the battery and recharge it for 24 hours
after the test.
-
Check the fastening screws of the wheel motor and of the shaft that
idles.
-
Check the distribution belt and maybe it must be changed. We must
evaluate the possibility to change the complete Pulley Kit and the belt
with the new model
-
Install, if it is not there, the contact spring (
050Z04400A)
as
indicated in the picture.
-
Check the keyboard it mustn’t be detached or raised up. In this case
we must change it in order to prevent water leakages inside the
robots.