Lay-Z-Spa 54112 Vegas Owner's Manual - 10.
Connect the pump to the spa by
lining up the letters (A to A, B to
B and C to C). Securely hand-tighten
the adapters. Check all rubber seals
are in place.
6.
7.
8.
Using a garden hose, fill the spa to the
minimum water level printed on the spa wall.
NOTE:
Before filling, ensure the bottom drain
valve was secured.
9.
Spread out the spa.
1.
Inflate the spa wall.
2.
Ensure that the inner spring valve is not depressed.
(
if
depressed, press the spring valve and turn counter clockwise
)
Attach the pressure gauge onto the hose of high pressure hand
pump, inflate the spa to 0.048MPa (7PSI) ~ 0.069MPa (10PSI)
ASSEMBLY: MONACO
(#54113)
Unscrew the
air-valve on the
spa wall.
IM
P
O
R
TA
N
T
N
O
T
IC
E
T
hi
s
un
it
wi
ll a
uto
lo
cko
ut a
fter
5 min
utes. To lock or unlo
ck pla
ce fi
nge
r o
ve
r
fu
nc
tio
n f
or
3
s
ec
on
ds
.
Test
Activate the Lay-Z-Massage system
and inflate the inflatable cover.
5.
Connect the
inflation hose to
adapter A on the pump.
4.
Inflate the four
inflated
cushions with the high
pressure hand pump.
3.
1
2
6
To heat the water, put the cover on, lock the clips, and push the
heat button (see page 7).
10.
WARNING:
Do not run the Lay-Z-Massage system
when the cover is attached, air can accumulate inside
the spa and cause irreparable damage and bodily
harm.
WARNING:
This spa cover is not a safety cover and is
not a substitute for adult supervision; children must be
supervised around the spa at all times.
Note:
We recommend you
take a shower before using
your Lay-Z- Spa, as cosmetic
products, lotions, and other
residues on the skin can
quickly degrade water quality.
S-S-001409
Remove the two stopper caps
from the inside of the spa’s inlet
and outlet pipes.
Screw the filter set to the inside
of the spa’s outlet pipe (NOTE:
Must screw in lower position).
NOTE:
Do not sit on the filter set.
X