LAZBOY LZ6220 Installation manual - page 8
Note:
When programming AUX 1-8 devices, the device mode
key backlight will be green.
Suggestion:
- If you cannot find a correct Device Code for your
equipment, refer to the section that follows: How To
Set Up The LR - By Searching Through the Library.
-
For future reference it is recommended to make a note
of your Device Codes on the label provided at the
bottom of the charging cradle after setting up your LR
correctly.
3.2.
By Searching Through the Library
If you cannot identify a correct Device Code for your
equipment from the Device Code list, you may search
through the code library:-
3.2.1. Turn on your device manually (e.g. TV).
3.2.2. Press a desired Device Mode Key (e.g. TV). The
red device mode key will light up.
3.2.3. Hold down "
CHANNEL+
" and "
VOLUME-
" on
the LR together simultaneously for 2 seconds until
the upper 4 red device mode indicators light up
(TV, DVD, SAT, VCR) The lower clear function
keys will also be lit and you will hear 2 beep tones.
3.2.4. Enter a corresponding Search Code from the
following table. The indicator should go out
immediately.
( e . g . p r e s s T V d e v i c e m o d e k e y, t h e n p r e s s
"
CHANNEL+
" and "
VOLUME-
", and enter The TV
Search Code 0001.) All device mode keys will flash
twice and turn off except the selected device if successful.
DEVICE
TYPE:
SEARCH
CODE:
TV
0001
VCR/LASER
DISK
0002
SAT
0003
CABLE
0004
DVD
14
DEVICE
TYPE:
SEARCH
CODE:
0005
AUDIO
0006
CD
0007
HOME
THEATER
0008
3.
HOW TO SET UP YOUR LA-Z-BOY
REMOTE (LR)
3.1.
By entering Device Code
You may setup your La-Z-Boy Remote (LR) by the
following code entering instructions.
3.1.1. Turn on your device (e.g. TV).
3.1.2. Refer to the LR Infra Red DEVICE CODE LIST;
look up the 4-digit Device Code which
corresponds to the brand of your A/Vequipment. If
there are more than one Device Code listed under
your brand, try from the first code.
3.1.3. Press a desired Device Mode Key (e.g. TV). The
red device mode key will light up.
3.1.4. Hold down "
CHANNEL+
" and "
VOLUME-
"
on
the LR simultaneously for 2 seconds until the red
upper 4 red device mode indicators light up (TV,
DVD, SAT, VCR) The lower clear function keys
will also be lit and you will hear 2 beep tones.
3.1.5. Use the number keys 0-9 to enter your 4-digit
Device Code.
All device mode keys will flash
twice and turn off except the selected device if
successful.
Then try the function keys (e.g. TV) on the LR. If your
device (e.g. TV) responds to your activated function
correctly, you have entered the right Device Code.
Otherwise, repeat the above setup with the next available
Device Code until your device (e.g. TV) responds to
your activated function, and most keys work correctly.
*
Simply repeat the above procedures to enter the
Device Codes for your VCR, SAT, DVD and other
Devices. (Remember to press a correct Device
Mode Key in step 2 above). For set up of
Auxiliary devices (AUX 1-8) press "
SHIFT
"
followed by the desired device key (AUX 1-8)
then follow steps 4-5 above.
13