LAZER ECOMOW470 Safety & Operating Instructions Manual - page 12
ECOMOW470 Cordless Electric Mower- Safety & Operating Instructions
11
Removing and Attaching Blade
Always check the blade for sharpness, damage, and tightness before and after each use. Replace
the blade promptly if it has been bent or damaged.
Removing the blade:
1.
Remove battery
.
2. Wear heavy gloves to protect hands from cuts and bruises. Turn the mower on its
right side (the side opposite the height adjustment lever) to expose blade.
3. Loosen the 19mm BLADE NUT with an ordinary
socket wrench, or similar (
Figure 14
). The blade
nut turns counterclockwise to loosen. Hold the
steel hex adapter steady with a screw driver to
prevent the motor shaft from turning, while
loosening the blade nut with the other hand.
4. Remove BLADE NUT, BLADE, AND BLADE
ADAPTER.
Figure 14
Attaching the blade:
1. To replace a sharpened blade or to install a new blade, reverse steps 1 through to 4
under the instructions for removing blade. Be sure to replace all parts exactly as
before removed (
Figure 15
). Observe the correct orientation of the blade.
2. Tighten the blade nut firmly.
To Mower
Blade Nut
Blade Adaptor
Figure 15