LAZER ECOMOW470 Safety & Operating Instructions Manual - page 5
ECOMOW470 Cordless Electric Mower- Safety & Operating Instructions
Assembling Your Mower
Step 1: Read the Safety & Operating Instructions before proceeding
For your safety, it is important to read the information in “Chapter 1: Important Safety Considerations” before
you assemble or use the Mower.
To familiarize yourself with the assembly, features, and operation of your Mower, please read the remainder
of this manual before proceeding.
Remove Battery
Step 2: Remove the Battery and Charge for the First Use
For your safety, please remove the battery before the assembly
process. To remove the battery, please open the battery cover
and simple take out the battery (
Figure 1
).
Now refer to Chapter 4 for how to charge the Battery for the first
use before continuing the assembling process.
Figure 1
The battery pack in your mower has been charged at the factory. However,
you must recharge the b
pack and make sure it is fully charged before initial operation of the mower.
attery
Failure to do so may
cause permanent damage of the battery pack.
Step 3: Attach and Adjust the Lower and Upper Handlebars
1. Insert the Lower Handlebar into the holes on the Upper housing.
2. Secure the Lower Handlebar with screws provided in the accessory pack (
Figure 2
).
3. Use the handlebar connector knobs and bolts to tighten the Upper Handlebar (
Figure 3
).
4. Use the two Cable Retainers to hold the main cable in place (
Figure 4
).
Cable
Retainers
Figure 4
Figure 3
Handlebar
Connector Knob
Bolt
Figure 2
4