LCD Concepts MES-6P-F User Manual - Features of The Mes-6P-F
2 |
P a g e
Features of the MES-6P-F
6 Port Switch
Six N-Way 10M/100Mbps auto-detect Ethernet/Fast Ethernet ports
Each port automatically negotiates between 10BASE-T and 100BASE-TX network speeds
Each port automatically negotiates between full and half-duplex modes
Any port can act as an Up-link to Fast Ethernet or down-link to Ethernet
“Plug-and-Play” installation with no software configuration necessary
Housings are made with marine grade aluminum and are powder coated inside and out for
long life
Rugged construction sealed to IP67 standards (compliant) for splash and dust
The electronics inside are coated with a corrosion blocker to further ensure reliability
Operating at maximum packet filtering and forward rate, supports for Store-and Forward of
packet switching
Buffer memory, 256Kbytes per device
8K MAC address entries per device
1 year warranty
Technical Specifications
Complies with IP67 standards
IEEE 802.3 (10Base-T Ethernet) and IEEE 802.3u (100Base-T Fast Ethernet) Standards
Class B digital device, pursuant to FCC, Part 15
Operating temperature………………… 0-50 Degrees C
Input Voltage……………………………..12-24 VDC
Maximum relative humidity……………..90% Non-condensing
Maximum power consumption…………11.25 Watts
Installation of the MES-6P-F Switch
This section will explain how to connect Ethernet devices to your MES-6P-F switch and how to mount
the switch.
Mounting the Switch
The MES-6P-F can be mounted in any orientation such as a flat surface, a wall or under a desktop.
Four mounting holes are provided; two on each end of the switch. Use four #6 screws for this
purpose. Make sure that there is at least 4” of clearance between all connectors on the MES-6P-F
and the nearest surface or object to allow the Ethernet and power cables to be plugged in. The
added clearance will also facilitate troubleshooting.
Dimensions of switch:
Length-
10 ½”, Width-8 ¼”, Depth- 1 ½”
Note: The width is measured from connector to connector