LCG 1207 User Manual - 9. Xlr Cable Connecting
DICE6 (LCG-1207)-User Manual
Pr63:6 colors jumping.
Pr64: 6 colors jumping + strobe
Pr65: multiple colors jumping
Pr66:multiple colors jumping + strobe
8. Operating Control Instruction
Master/Slave
Master setting:The master should be one of following modes: built-in modes, color
jumping Mode, fade mode, white strobe mode and manual dimming mode. It sends out
synchronizing signal. To avoid the master signal and DMX512 signal from interfering with
each other, we should cut off the DMX512 signal. When the signal cables are longer than 60
meters (32 sets) , a DMX signal amplifier is necessary.
Slave setting:It must be in the SLAV mode to assure receiving the master’s signals
correctly. Only one light can be set as a Master and others are slaves.
9. XLR cable connecting
XLR cable:
The standard way of connecting the XLR is: one end connects to the male plug, and the
other end connects to the female. As bellow: pin 1: ground, pin 2:
negative signal, pin 3:
positive signal
13