LCN LCN-GTS6 Installation Manual - Lcn-Gts6
6
Inscription
You will find the inscription software GT-Designer on our
homepage LCN.de in the download area, for creating captions
on your GT-inlays. The inlay must be cut to 61mm * 75mm.
Standard 80g printing paper is appropriate and easy to handle.
Semi-transparent paper/plastic sheet is even better for ideal
luminance of the status LED´s
Inserting the inlay into the key-sensor
Pull the plastic slide to the side (outwards) at the rear of the
key-sensor. Insert the inscripted inlay at the bottom side of the
LCN-GT6 (LCN-GTS6) into the groove until it resists.
Tip: If you cut off the corners of the inlay around 2 mm, it will
make it easier for inserting the inlay into the groove. When
changing the paper, remove the LCN-GT6 (LCN-GTS6) from
the wall.
LCN-GTS6
®
Installation guide
LCN-GT6
®
locked!
unlocked!