LCSI IPK-108 Installation & User Manual - page 27
27
Scan Rate
This sets the display duration for each computer displayed in Scan mode. Default settings are: 3 seconds, 8
seconds, 15 seconds, and 30 seconds.
CH-Display (Channel ID/Name Display)
There are two options:
Always On: The label with the Channel (i.e., port ID) number and name of the selected computer and/or OSD
status will be displayed on the screen all the time.
Auto Off: The label with the Channel ID and name of the selected computer and/or OSD status will be
displayed on the screen for 3 seconds, then automatically disappear.
Define Hot-key (Define Hot-key for OSD Menu)
The default hotkey to activate the OSD menu is CTRL>. Select any of the three hotkey options: CTRL>,
SHIFT>, or ALT>.
Operation remains the same, e.g., if you select SHIFT>, then pressSHIFT>twice activates the OSD, but you
still press CTRL> to go from the OSD Main Menu to the Setup Menu.
OSD Timer (OSD Timeout)
There are four options for the automatic timeout period of the OSD screen: 30, 45, 60 or 80 seconds. This
represents the amount of time the OSD remains showing. When it times out, the OSD turns off. Double press
your designated hotkey (default: CTRL>CTRL>) if you want it to appear again.
OSD Position (OSD
Display Position)
To set up the position of selected computer name and/or OSD status displayed on screen during operation.
Use the , to select Up Left, Up Right, Middle, Low Left, and Low Right.
The actual display position depends somewhat on VGA resolution.
Switch Hotkey
The value of default hotkey to switch port is OFF. Select any of the three hotkey options: CTRL>, SHIFT>, or
ALT> to enable the switch hotkey function.
Operation is to press the hotkey twice then enter the port no. For example, if you select SHIFT> for your
switch hotkey and want to switch to port 1, pressSHIFT>twice and Enter
“1”.
Admin Password
Once the Admin Password protection is set, you can only access the OSD menu by supplying the assigned
password. Don‟t forget it. The Admin Password is also used to access computers protected with the Security
“!” setting. (See F3: Security.) To change a new password, please enter the OLD password and set a new one.
In the event of a password lost, you need to reset this unit back to default password. (To know how to reset
CAT5 KVM to default, please contact your dealer)
Rest Mode Timer
This sets the timeout timer, the amount of time the system remains in active KVM mode if undisturbed (no
keyboard or mouse activity). If undisturbed for more than the set amount of time, the CAT5 KVM goes to sleep,
and the monitor goes black.
The options are: 0 Minutes, 1 minute, 5 minutes, and 10 minutes.0 means never
sleep.