LDC Racing Sailboats RS200 Owner's Manual - page 14
14
taught). Ensure the downhaul line is free to follow the spinnaker out of the
chute ( you are not standing on it). Unless something becomes fouled the sprit
should have precedence over the halyard as it has a 2:1 purchase advantage.
Sheet in using the appropriate sheet. Check again that the halyard/downhaul
is not caught and distorting the spinnaker
Now treat the spinnaker virtually like a large jib.
As with a jib or a conventional spinnaker for that matte r pay attention never to
over sheet the sail. The spinnaker sheets should be played constantly in an
attempt to keep the luff of the sail just on the edge of collapse. With practice
at the onset of a gust especially on a tight reach the luff of the sail can be
partially rolled to help keep the boat on a level keel and travelling at her
maximum speed.
It is a characteristic of the asymmetric spinnaker that it will develop
considerable lee helm at times particularly if the main has to be eased to any
extent. For this reason it should never be necessary to raise the centreboard
when reaching and is perfectly acceptable to sail the boat with a slight heel to
leeward to obtain a neutral helm. The hull shape has been designed with this
consideration in mind.
Gybing
Gybing an asymmetric spinnaker is simplicity itself but as with most
manoeuvres there are a few simple tricks which can help with the efficiency of
the process.
They are not going to like hearing this but the helmsman holds the key to a
perfect gybe! The speed with which you enter the gybe and the amount by
which you allow the boat to round up after the boom has crossed over affect
the success of the gybe fundamentally. Don’t bear away too quickly. Try to
bear away smoothly allowing the crew sufficient time to adjust the sheets and
maintaining speed. In preparing for the gybe the crew should have released
the old jib sheet and set the new one loosely on the windward side then taken
as much slack out of the new spinnaker sheet as possible. The crew should
resist the urge to let go of or ease the old sheet too far. In fact it will help if the
crew gives the old sheet a final tug in at the last moment before the boom
goes over and subsequently sheets in smartly on the new sheet. Coming out
of the gybe if the conditions allow the helmsman should permit the boat to
round up sufficiently to fill the spinnaker as quickly as possible before bearing
away smoothly to the new course. Timing is the essence and practice makes
perfect.
To hoist in running mode - locate the check line knot in the “V” notch and
pull on the spinnaker halyard until the spinnaker has reached the top ( in this
case the sheave box above the hounds). Pull on the windward sheet and set
as if goose winging a jib. Setting the spinnaker goose winged on the run is not
easy, it requires accurate course control and co-ordination but can have
marked performance advantages particularly in restricted and tidal waters. It
certainly adds another fascinating dimension to down wind tactics. The finer
points of goose-winged running are still to be discovered.