Le Club SWELL-6x10WH User Manual - 3 - Rear Panel Description
Swell-6x10WH - 6x10 W white LEDs multi-beam rotating bar
Page 17
English
3 - Rear panel description
1
Power input
Allows you to connect the projector to an electrical outlet.
Please make sure the voltage is in adequation with the product
indications.
2
DMX input
3-pin female XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
3
Indicator LEDs
These 4 LEDs indicate the device status.
LED
Indication
DMX
Is ON when the DMX mode is activated
MASTER
is ON when the Master mode is activated
SLAVE
is ON when the Slave mode is activated
SOUND
Flashes when the Sound-sensitive mode is
activated
4
Menu settings
MENU
Press MENU to access and select the functions.
ENTER
Press ENTER to access a sub-menu and or save changes
selected via the UP and DOWN buttons.
UP and DOWN
Press UP or DOWN to increase/decrease the adjustable values
or browse the sub-menus.
5
Display
This intuitive display allows you to configure your projector.
Please refer to the next paragraphs for more details about
the projector configuration. The display backlight can be
deactivated via the Back Light command menu.
6
Microphone
The microphone is used for the music-sensitive modes.
7
Stereo Jack 6.35 input
This input allows you to plug in the EASY-2 optional remote
control.
Only the EASY-2 remote control should use this input, as
plugging other devices may result in severe damages to the
internal electrics.
8
DMX output
3-pin male XLR plug hardwired as follows :
- Mass: 1
- Negative signal: 2
- Positive signal: 3
9
Power output sock
Allows you to link two projectors together via a Male/Female IEC
cord. You can daisy chain up to 8 projectors.
3
4
1
2
6
7
8
9
5