Le maitre ® mvs hazer operating manual the mvs is a high technology, feature rich hazer machine. All features are variable and storable. High haze output is variable down to a whisper twin projection fans are variable from 2800ft/min velocity down. Haze output direction is electronically variable fr...
Introduction the le maitre mvs hazer is the latest in the range of high specification hazers and as such will fulfil the majority of applications where higher demands are required. It utilizes the original and patented technique of producing haze via an easily replaceable ‘conversion’ tube, whilst a...
Safety and cautions all electro-mechanical machines have the ability to cause injury, either mechanically or electrically. The user should be fully aware of the correct operational procedures involved in the use of this machine, and should feel comfortable about being in control of it. All users sho...
M.V.S. Specifications power source requirements 230vac 300 watt 50hz external fusing 3.15at ceramic internal fusing 500ma pcb transformer vlm (very low mass) stainless steel replaceable vapour tube virtually instant operation fluid capacity 2.5 litres bottle carrier fluid use - max 100cc / hr. Min 1...
Fluid use please note that the fluid used with the mvs hazer is not like any other fluid used typically in smoke or hazer machines. It is a high concentration fluid, which other manufacturers’ machines are unable to process without incurring damage. Do not attempt to water down the haze fluid … this...
Operation instructions all features are adjusted and set up using the main control panel. Three buttons on the left hand side: these select the mode of operation i.E. Dmx or manual and also allow settings to be stored. Just press the corresponding switch for the desired mode. All adjustments are mad...
The haze button allows an instant on/off switching in the manual mode, so that the haze output setting need not be reduced to zero in order to switch the effect off. 7.
Cycled feature explanation.. Haze volume of haze vapour produced proj output power of fans effecting projection distance dir relative power of fans effecting angle of projected haze swp speed of automatic direction variation, sweeping the output of haze. This overrides the direction setting, and can...
When the machine is switched on, it will perform a single cleaning process routine. This will last approximately 2 minutes. This is a very short time compared to alternative systems which have to heat a standard type heat exchanger. After this operation the machine will be ready to operate. Initial ...
Modes of use and positioning the mvs can be used in its standard upright position, with or without the optional fluid carrier attached. Its slim design will take minimal floor space and allow it to be conveniently placed. The variable angle of haze output will also allow it to be positioned in awkwa...
As with any ‘hot vapour’ type machine, it should never be positioned such that any hot fluid could be projected, or drip onto personnel, and it is the responsibility of the installer / operator to ensure that this cannot occur. The best continuing performance will be obtained by turning the haze off...
Haze tube tube replacement will not be expected, but should it be required, then all the necessary safety precautions should be made before doing so - the machine is not connected to the mains supply. The machine is placed on a suitable work surface. The machine has been allowed to cool for at least...
