Le Maitre MVS Operating Manual - page 9
When the machine is switched on, it will perform a single cleaning process routine.
This will last approximately 2 minutes. This is a very short time compared to
alternative systems which have to heat a standard type heat exchanger. After this
operation the machine will be ready to operate. Initial Haze output might take a
short while to reach a steady state due to the fact that the cleaning process will have
cleared to fluid supply line. After this initial settling state, operation will be
immediate.
Manual Operation
When the machine has performed the initial cleaning routine, it will be ready to
operate. Pressing the Manual button will make operation available via the control
panel.
By pressing the Select button each of the features can be adjusted to suit the
operating requirements. Use the Up / Down buttons to adjust.
Haze output..
Set how much haze volume is required
Projection
Set how far the haze will be fanned
Direction
At
what
angle
is the projection required
Sweep
Speed of automatic sweeping haze or fixed angle (Off)
( Note.. if Sweep is on, then Angle 0 degrees = 0 to 45 sweep, Angle 45 degrees = 0 to
90 sweep, Angle 90 degrees= 45 to 90 sweep )
The DMX channel assignment and channel options are irrelevant in Manual mode.
All that is required now is the use of the Haze button. Press for On, Press again for
Off.
If the settings are required to set as defaults in memory, then at each final
adjustment press the Manual and Store keys at the same time. When the machine is
switched on again, these settings will be restored.
DMX Operation
Before using DMX set the required first channel (Haze volume) by selecting Manual
mode, then use the Select button to select the DMX feature. Press the Up or Down
button (hold down to auto increment or auto decrement, the longer held the faster
the change) to reach the desired channel. The next 3 channels are automatically
assigned to Projection, Direction and Sweep. If their use (or individual use) is not
required then select Use2,3,4 and choose Yes or No to use or ignore. If a channel is
set to ‘not use’ then that channel is available for other devices and will not be
responded to. Again, to commit these settings to memory, use the Manual and Store
buttons together.
Once the DMX parameters are set, then use the DMX button to change the mode of
the panel into DMX control. If DMX control is desired from switch on, then commit
the DMX control to memory by pressing the DMX and Store buttons together.
9