Summary of Stage Fogger DMX
Page 1
Lemaitrefx.Com stage fogger dmx operations manual v.06.29.05.
Page 2
Lemaitrefx.Com page 1 introduction page 2 warning page 3 safety precautions page 4 technical specifications page 5 operating procedure page 6 remote handset operations page 6 dmx control procedure page 7 remote handset image page 7 dmx control image page 8 stage fogger dmx tube change procedure imag...
Page 3
Lemaitrefx.Com 1 the stage fogger dmx is a microprocessor controlled, water base fog generating system. The microprocessor is responsible for the following control elements - monitoring the heat exchanger temperature. Driving the heater within the heat-exchanger. Driving the fluid pump unit, relatin...
Page 4
Lemaitrefx.Com 2 m.S.D.S. Available at www.Lemaitrefx.Com important safety instructions: do not touch or place hands, expose skins, within 50 cm. Of discharge nozzle. Important safety instructions: do not remove the outer case until power has been disconnected from the machine. Important safety inst...
Page 5
Lemaitrefx.Com 3 1. Ensure that operation of the machine is supervised by suitably trained and authorised personnel. 2. Do not modify the machine or use a machine which has been damaged in any way. 3. Allow sufficient air circulation around the machine at all times. 4. Protect the stage fogger dmx f...
Page 6
Lemaitrefx.Com 4 technical specifications stage fogger dmx model: stage fogger dmx type: water base fog generating system size: height: 10 3/4” 27.3 cm. Width: 10 3/8” 26.3 cm. Length: 25 1/2” 63.5 cm. Net weight: 13.6 kg. 30 lbs. Weight with fluid 17.7 kg. 39 lbs. Power rating: 110 volt a.C.50/60 h...
Page 7: Operating Procedure
Lemaitrefx.Com 1) the stage fogger dmx must only be connected to a grounded mains supply capable of sustaining at least 15 amps. The supply should be ‘clean’ and free of interfer- ence. 2) open a container of le maitre fog fluid , remove cap and break foil seal (if provided). Remove cap from stage f...
Page 8
Lemaitrefx.Com 6 1. The fog output time is set using the ‘duration’ control. 0 to max, and the time between successive fog outputs is set using the ‘interval’ control. 0 to max. Continual flow can be achieved if ‘interval’ setting is 0 (figure 1, page 7). The standard remote handset cable may be ext...
Page 9
Lemaitrefx.Com 7 remote handset image duration control interval control vari flow control fog on/off switch handset indicator figure 1 external connector and dmx operation figure 2.
Page 10
Lemaitrefx.Com 8 stage fogger dmx tube change images figure 4 figure 5 figure 6 two screws protective shield.
Page 11
Lemaitrefx.Com 9 1. Remove the eight screws from the case. Six are under the lip at mid level and two are on top. Slide the upper cover forward and remove it from the machine. Lift the jug up and out of the way (figure 3). 2. Remove the two screws from the front edge of the block cover. Slide the co...
Page 12
Lemaitrefx.Com 10 the casing of the stage fogger dmx is steel with a powder paint coating. To clean simply wash with mild soap and warm water. With normal use we do not recommend flushing or cleaning the heat exchanger, with the use of genuine le maitre fluids. Using high quality le maitre fluid sho...
Page 13
Lemaitrefx.Com 11 pro beam (long lasting) fog fluid: we have had many compliments on our fog fluid but many of our customers would like it to hang longer so we introduced the “long lasting fluid”. It is still odourless but a little less white than our “director’s choice”. It hangs in the air 2 - 3 t...
Page 14
Lemaitrefx.Com 12 warranty: all warranty is one year parts and labour unless specified and is on manufacturer defect only. Abuse or poor maintenance is not accepted. Le maitre fluids must always be used. Any trace of other fluids will automatically void all warranties. Accept no substitutions as the...