Le Maitre Stage Fogger DMX Operation Manual - page 11
lemaitrefx.com
9
1. Remove the eight screws from the case. Six are under the lip at mid level and two are
on top. Slide the upper cover forward and remove it from the machine. Lift the jug up
and out of the way
(Figure 3).
2. Remove the two screws from the front edge of the block cover. Slide the cover
backward to release the two back tangs from the lower cover and lift the cover off.
3. Remove the two screws on the rear of the machine in order to remove the protective
shield
(Figure 4 & 5, Page 8).
4. Unfasten the tube by releasing the 7/16” brass nut at the pump. This line may be
under significant pressure if the tube was plugged.
5. Be careful not to damage any exposed wiring. Remove the upper steel plate by loosen-
ing the five nuts with a 1/2” socket. Gently lift the plate back out of the way leaving
the high temperature switch undisturbed.
6. Lift the aluminum plate up cautiously to avoid damage to the Thermal sensor
(Figure
6, Page 8).
7. Remove the copper tube and two thin aluminum wear plates.
Stage Fogger DMX Tube Change Procedure
The block contains extremely hot surfaces and liquids. These will cause
severe burns on contact. Please unplug power to eliminate electrocution
hazard and allow the unit to cool before attempting to service the block.
Figure 3