Lea LE25254BP Instruction Manual - 8. Maintenance and Service
15
not operate the brush
cutter in areas with
metallic materials. Always use the
proper protective equipment. Don’t
use this machine in areas where
you can’t see properly.
7.2. CUT WITH THE DISC
and there are no signs of damage or abrasion.
installed in accordance with the instructions and
that the disc spins freely without producing
abnormal
sounds.
7.2.1. CUTTING METHOD:
1. Cut with the left front of the disc
slightly inclined to the left.
IMPORTANT:
- Only use this machine to cut grass. Do not let
the disc touch materials that can not cut as stones,
metals, hard wood, wire mesh, etc.
- Keep the blade sharp. A bad sharpened disc cause
a higher cutting force on the machine as well as
- Keep the area to be cut clean with no traces of
chopped vegetables or other materials.
It is necessary to always turn off the engine and
transporting or modify the cutting tool.
and areas near the air filter.
Never try adjustments in the machine if it is running
and / or attache to the user by the harness. Perform
all maintenance of the machine when is set on a flat
and clear surface.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
people around the machine.
Before performing any maintenance or repair the
that the machine is correct. For a thorough inspection
Air filter
- The dirt in air filter will cause a reduction in
element. If you notice damage or alterations
replace it with a new filter.
Carburetor adjustment
- Carburetor adjustment is complicated and should
be done only by the service.