Lea LE25326D Original Instructions Manual - Special Satety Warning
4
-
Walk, never run.
-
Exercise extreme caution when changing direction on slopes.
-
Do not cutting excessively steep slopes.
-
Use extreme caution when reversing or pulling the appliance towards you.
-
Never operate the appliance with defective guards or shields, or without safety devices.
-
Switch on the motor according to instructions and with feet well away from the blade(s).
-
In this case, do not tilt it more than absolutely necessary and lift only the part which is
away from the operator. Always ensure that both hands are in the operating position
before returning the appliance to the ground.
-
Do not put hands or feet near or under rotating parts.
-
Never pick up or carry an appliance while the motor is running.
-
Pull the spark from the socket:
· whenever you leave the machine;
· before clearing a blockage;
· before checking, cleaning or working on the appliance;
· after striking a foreign object. Inspect the appliance for damage and make repairs as
necessary;
· if the appliance starts to vibrate abnormally (check immediately).
4)
Maintenance and storage
-
Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working condition.
-
Check the grass catcher frequently for wear or deterioration.
-
Replace worn or damaged parts for safety.
-
For rotary mowers, ensure that only replacement cutting means of the right type are used.
-
Never store the equipment with petrol in the tank inside a building where fumes can reach
-
an open flame or spark;
-
Allow the engine to cool before storing in any enclosure;
-
To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol
storage area free of grass, leaves, or excessive grease;
-
If the fuel tank has to be drained, this should be done outdoors.
SPECIAL SATETY WARNING
1.
Grip the handles of the brush cutter firmly with both hands. If you suspend
the work, Place the throttle into the idling position.
2.
Always be sure to maintain a steady, even posture while working
3.
Maintain the speed of the engine at the level required to perform cutting
work and never raise the speed of the engine above the level necessary.
4.
If the grass gets caught in the blade during operation , or if you need to
check the unit of refuel the tank always be sure to turn off the engine.
5. If the blade touches a hand object like a stone immediately stop the engine
and check it something is wrong with the blade. If so,replace the blade by new
one .
6. If someone calls out white working , always be sure to turn off the engine before turning
around.