Leadsun pbox x3 User Manual - page 6
Nuts
Type C: Install Lamp on an Arm Pole
C1. Find two holes on both sides of the frame. Place two
nuts individually into the slots. Insert the screws
through the holes and secure the nuts (as shown in
the picture on the left).
C2. Inset the lamp base in the frame, and then insert the
arm pole into the lamp frame. Fasten the screws with
the Anti-theft Spanner (as shown in the picture on the
left).
Type D: Install with LEADSUN Optional Lamp Post.
D1. Insert the lamp pole into the bracket. Make sure to
match the holes on the lamp pole with the snap joints
on the base.
D2. Joint the bracket with three pins at the corresponding,
and tighten them by screws (as shown in the picture of
the left).
D3. Fill the Water Base with water.
Place three Water Base unto the base pins to stabilize
the lamp post (as shown in the picture on the left).
EN
9
10