Lec TF6096W User Manual - Gb/ie
GB/IE
Instruction for use
11
Operation of the control panel
(Fig 5)
The control panel is used for adjusting and
displaying the temperatures within the appliance
and has the following functions:
1 – Fast freeze button
2 – Freezer temperature display
3 – Orange led – Fast freeze on
4 – Green led – Power on
5 – Red led – Alarm
6 – Refrigerator temperature display
7 – Temperature setting button
Accoustic signalling
When the door of the refrigerator remains open for
more than 1 minute, an intermittent audio alarm is
activated.
If the door of the refrigerator is shut, the audio alarm
stops.
Fan
The fans circulate the cold air in both compartments.
It is connected electrically in parallel with the motor-
compressor. When the motor-compressor is off, the
fan will also be off.
The fan of the refrigerator stops 1 second after the
opening of the door and starts 1 second after its
closing.
In some cases it is possible that the fan in the
freezer compartment starts with a delay
compared to the motor compressor.
Lamp
The lamp comes on after the opening of the
door and remains on until it is closed.
Adjustment of the temperatures in the
refrigerator and in the freezer
The temperatures are adjusted by rotating the
temperature adjustment knob (7) from MIN
towards MAX. On the temperature display the
new value of the fridge temperature (6) will
blink for 5 sec. Then the current value read by
the fridge sensor will be displayed.
The freezer display will show the
corespondent temperature for the freezer.
The inside temperatures of the refrigerator
and of the freezer are correlated as follows:
Refrigerator
adjusted
temperature
Freezer
corresponding
value
+ 8
- 18
+ 7
- 19
+ 6
- 20
+ 5
- 21
+ 4
- 22
+ 3
- 23
+ 2
- 24
The inside temperatures can vary
according to the conditions of use of the
appliance: location, ambient temperature,
frequence of door opening, ammount of
food stored. The temperature adjustment
will need to be modified accrodance with
these conditions.
Generally, for an ambient temperature of
25
0
C, when the appliance is first switched on,
the temperature should be set to an average
position of 4
or 5
.
This position can be subsequently
adjusted towards plus or minus according
to the wish of each user.
During the operation of the appliance,
condensation drops or ice appear on the
inside back wall. You do not need to remove
these drops, because the back wall is
automatically defrosted. The water which
results leaks in the special groove and is
collected in a tray placed near the
compressor, from where it evaporates.