Lectronics DM1612F Hardware And Software Installation Manual - page 13
DM Series Installation Guide
Rio Rancho, NM
13
USB Driver Installation (Windows 2000)
First Time Installation
When a LecNet2™ device is connected to a comptuer
system running the Windows
®
2000 operating system
for the very first time, the Windows
Found New Hard-
ware Wizard automatically opens.
Use the following procedure to install the LecNet2™
USB driver using the Wizard.
1. Connect a cable between the DM processor USB
port and the computer system. Place the Lec-
Net2™ Installation Disk in the computer system’s
CD-ROM drive and click
Next> to continue.
2. Select “Search for a suitable driver for my de-
vice (recommended)” and click Next> to continue.
3. Check “CD-ROM drives” then click Next> to search
the LecNet2™ CD for the USB driver.
4. When it is found, the LecNet2™ device name will
be displayed. Click
Next> to install the driver.
5. When the driver installation is complete, the final
page of the Wizard appears. Click
Finish. It is now
possible to connect to the LecNet2™ device.