- DL manuals
- Lectrosonics
- Transmitter
- UT
- Instruction Manual
Lectrosonics UT Instruction Manual
Summary of UT
Page 1
Ut synthesized uhf hand-held transmitter featuring digital hybrid wireless ™ technology (us patent 7,225,135) instruction manual rio rancho, nm, usa www.Lectrosonics.Com fill in for your records: serial number: purchase date:.
Page 2
Ut lectrosonics, inc. 2.
Page 3
Synthesized uhf hand-held transmitter rio rancho, nm 3 table of contents general technical description ..............................................................................................................................................................4 introduction ...........................
Page 4
Ut lectrosonics, inc. 4 general technical description introduction the ut digital hybrid wireless™ handheld transmitter uses state-of-the-art wireless technology with a high- powered 100mw rf output and a unique microphone capsule arrangement. The varimic™ preamp allows the user to custom-tailor the...
Page 5
Synthesized uhf hand-held transmitter rio rancho, nm 5 compatibility modes the transmitter was designed to operate with lec- trosonics digital hybrid wireless™ receivers and will yield the best performance when doing so. However, due to the flexibility of digital signal processing, it is also able t...
Page 6
Ut lectrosonics, inc. 6 power on/off switch a power on/off switch located on the outside bottom of the unit turns the unit on and off. The function of the power on/off switch can also be changed so it also operates as an audio mute switch. In this configuration, the power led doubles as a battery st...
Page 7
Synthesized uhf hand-held transmitter rio rancho, nm 7 opening the battery compartment modulation leds -20 -10 audio level coarse fine frequency switches modulation (audio level) leds the two bicolor modulation leds (located under the battery compartment cover) provide a visual indica- tion of the a...
Page 8
Ut lectrosonics, inc. 8 varimic ™ controls caution: due to the high rf levels surrounding the transmitter, the sound of the varimic ™ capsule may be temporarily affected if the metal windscreen is not in place. Always make the final decision about sound balance and quality with the windscreen in pla...
Page 9
Synthesized uhf hand-held transmitter rio rancho, nm 9 subsonic noise filter in addition to the tone controls, the ut also has a built- in subsonic noise (or high pass) filter. This filter is fixed and cannot be adjusted or defeated. Low frequency noise is much more of a problem with wireless micro-...
Page 10
Ut lectrosonics, inc. 10 changing capsules 1) remove windscreen 2) loosen and remove the two socket head bolts that attach the capsule to the microphone body 3) lift capsule assembly 4) disconnect 3-pin con- nector 5) connect new capsule 6) set new capsule assembly to align the holes for the socket ...
Page 11
Synthesized uhf hand-held transmitter rio rancho, nm 11 7) insert and tighten both socket head bolts 8) replace windscreen note: older units may have phillips head bolts. Please use the supplied socket head bolts to install the new capsule..
Page 12
Ut lectrosonics, inc. 12 selecting compatibility mode this transmitter is capable of working with lectrosonics 400 series digital hybrid wireless™, 200 series, 100 series, and some analog wireless receivers from other manufacturers. (contact lectrosonics for details.) the transmitter must be set for...
Page 13
Synthesized uhf hand-held transmitter rio rancho, nm 13 on/off switch function selection the on/off switch can be configured to control power or to function as an audio mute switch. When it is con- figured as an audio mute, the transmitter power can still be turned off by starting with the switch in...
Page 14
Ut lectrosonics, inc. 14 the transmitter is powered by a standard alkaline, lithium or lipolymer rechargeable 9 volt battery. Alka- line batteries will provide about 3.5 hours of operation, a lithium battery about 6.5 hours, and a lipolymer bat- tery about 4 hours per charge. Note: the battery statu...
Page 15
Synthesized uhf hand-held transmitter rio rancho, nm 15 operating notes the audio level control should not be used to control the volume of the overall sound system or recorder levels. This gain adjustment is used to match the trans- mitter gain with the user’s voice level and microphone position. I...
Page 16
Ut lectrosonics, inc. 16 symptom possible cause ut power led off 1) battery is inserted backwards. 2) battery is dead, or too low to be used. Ut modulation leds off 1) audio level control turned all the way down. 2) battery is in backwards. Check power led. 3) mic capsule is damaged or malfunctionin...
Page 17
Synthesized uhf hand-held transmitter rio rancho, nm 17 operating frequencies: block 470: 470.100 - 495.600 block 19: 486.400 - 511.900 block 20: 512.000 - 537.500 block 21: 537.600 - 563.100 block 22: 563.200 - 588.700 block 23: 588.800 - 607.900; 614.100 - 614.300 block 24: 614.4 00 - 639.900 bloc...
Page 18
Ut lectrosonics, inc. 18 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnecting cables and then go th...
Page 19
Synthesized uhf hand-held transmitter rio rancho, nm 19.
Page 20: Limited One Year Warranty
30 oct 2008 581 laser road ne • rio rancho, nm 87124 usa • www.Lectrosonics.Com (505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.Com limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workmanship provided i...