- DL manuals
- Lectrosonics
- Transmitter
- UT
- Instruction Manual
Lectrosonics UT Instruction Manual
Summary of UT
Page 1
Ut synthesized uhf hand-held transmitter featuring digital hybrid wireless ® technology* instruction manual rio rancho, nm, usa www.Lectrosonics.Com fill in for your records: serial number: purchase date: *us patent 7,225,135.
Page 2
Ut lectrosonics, inc. 2.
Page 3
Synthesized uhf hand-held transmitter rio rancho, nm 3 table of contents general technical description ..............................................................................................................................................................4 introduction ...........................
Page 4
Ut lectrosonics, inc. 4 general technical description introduction the ut digital hybrid wireless™ handheld transmitter uses state-of-the-art wireless technology with a high- powered 100mw rf output and a unique microphone capsule arrangement. The varimic™ preamp allows the user to custom-tailor the...
Page 5
Synthesized uhf hand-held transmitter rio rancho, nm 5 compatibility modes the transmitter was designed to operate with lectro- sonics digital hybrid wireless™ receivers and will yield the best performance when doing so. However, due to the flexibility of digital signal processing, it is also able t...
Page 6
Ut lectrosonics, inc. 6 power on/off switch a power on/off switch located on the outside bottom of the unit turns the unit on and off. The function of the power on/off switch can also be changed so it also operates as an audio mute switch. In this configuration, the power led doubles as a battery st...
Page 7
Synthesized uhf hand-held transmitter rio rancho, nm 7 frequency switches two 16-position rotary switches (located under the bat- tery door) adjust the operating frequency of the trans- mitter. The coarse switch adjusts the frequency in 1.6 mhz steps and the fine switch adjusts the frequency in 100 ...
Page 8
Ut lectrosonics, inc. 8 varimic™ controls caution: due to the high rf levels surrounding the transmitter, the sound of the varimic tm capsule may be temporarily affected if the metal windscreen is not in place. Always make the final decision about sound balance and quality with the windscreen in pla...
Page 9
Synthesized uhf hand-held transmitter rio rancho, nm 9 subsonic noise filter in addition to the tone controls, the ut also has a built- in subsonic noise (or high pass) filter. This filter is fixed and cannot be adjusted or defeated. Low frequency noise is much more of a problem with wireless micro-...
Page 10
Ut lectrosonics, inc. 10 changing capsules 1) remove windscreen 2) loosen and remove the two screws that attach the capsule to the micro- phone body 3) lift capsule assembly 4) disconnect 3-pin con- nector 5) connect new capsule 6) set new capsule assembly to align the holes for the socket head bolt...
Page 11
Synthesized uhf hand-held transmitter rio rancho, nm 11 7) insert and tighten both socket head screws 8) replace windscreen the latest mounting kit includes hex head screws and lock washers. These replace earlier types of screws and vibratite (loctite) sealer. Kit includes a spare screw and washer.
Page 12
Ut lectrosonics, inc. 12 selecting compatibility mode this transmitter is capable of working with lectrosonics 400 series digital hybrid wireless™, 200 series, 100 series, and some analog wireless receivers from other manufacturers. (contact lectrosonics for details.) the transmitter must be set for...
Page 13
Synthesized uhf hand-held transmitter rio rancho, nm 13 5) once the audio gain has been set, the signal can be sent through the sound system for overall level adjustments, monitor settings, etc. Power on/off switch function selection the power on/off switch can be configured as an audio mute switch....
Page 14
Ut lectrosonics, inc. 14 the transmitter is powered by a standard alkaline or lithium 9 volt battery. Alkaline batteries will provide about 3.5 hours of operation while the lithium batteries will operate the transmitter for about 6.5 hours. Note: the battery status lamp will function normally only w...
Page 15
Synthesized uhf hand-held transmitter rio rancho, nm 15 operating notes the audio level control should not be used to control the volume of the overall sound system or recorder levels. This gain adjustment is used to match the trans- mitter gain with the user’s voice level and microphone position. I...
Page 16
Ut lectrosonics, inc. 16 symptom possible cause ut power led off 1) battery is inserted backwards. 2) battery is dead, or too low to be used. Ut modulation leds off 1) audio level control turned all the way down. 2) battery is in backwards. Check power led. 3) mic capsule is damaged or malfunctionin...
Page 17
Synthesized uhf hand-held transmitter rio rancho, nm 17 operating frequencies: block 21 537.600 - 563.100 block 22 563.200 - 588.700 block 23 588.800 - 607.900 and 614.100 - 614.300 block 24 614.400 - 639.900 block 25 640.000 - 665.500 block 26 665.600 - 691.100 block 27 691.200 - 716.700 block 28 7...
Page 18
Ut lectrosonics, inc. 18 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnect- ing cables and then go ...
Page 19
Synthesized uhf hand-held transmitter rio rancho, nm 19.
Page 20
14 july 2011.
Page 21
Ucr100 uhf multi-frequency compact receiver instruction manual rio rancho, nm, usa www.Lectrosonics.Com fill in for your records: serial number: purchase date:.
Page 22
Ucr100 lectrosonics, inc. 2.
Page 23
Compact receiver rio rancho, nm 3 introduction thank you for selecting the lectrosonics multi-fre- quency, ucr100 receiver. The ucr100 is the result of extensive engineering experience with the very latest microprocessor advancements and technology. The lectrosonics 100 system receiver and companion...
Page 24
Ucr100 lectrosonics, inc. 4 general technical description features the multi-frequency ucr100 fm receiver is designed to operate with the lectrosonics um100 transmitter and features microprocessor control of 256 frequencies of operation within each frequency block. Each block cov- ers 25.5 mhz with ...
Page 25
Compact receiver rio rancho, nm 5 modulation leds the two modulation led’s indicate the modulation (audio level) of the incoming signal and can be used for proper adjustment of the transmitter’s mic or audio level. The -20 led glows when the transmitter modulation is at a high enough level to produc...
Page 26
Ucr100 lectrosonics, inc. 6 1.6m 100k audio level control attenuates the audio output level of the receiver to match the input requirements of the equipment with which it is used. The 3.5mm mini output jack on the front panel provides an audio output at adjustable levels for low or high impedance, u...
Page 27
Compact receiver rio rancho, nm 7 1. Install the battery. 2. Set the “frequency” switches on the side panel to match the switches on the transmitter. 3. Connect the audio cable. 4. Set the front panel switch to on. Check to see that the red power led lights up. 5. This is perhaps the most important ...
Page 28
Ucr100 lectrosonics, inc. 8 before going through the following chart, be sure that you have a good battery in the receiver. The power led should glow brightly. Symptom possible cause no power led 1) receiver switch in “off” position 2) dead or weak battery 3) battery missing 4) battery installed bac...
Page 29
Compact receiver rio rancho, nm 9 available frequencies: 537.6 to 608 mhz, 614 to 691.1 mhz (blocks 21 through 26) each unit operates on a single block. Number of frequencies per block: 256 in 100 khz steps channel spacing: 100 khz frequency control: crystal controlled phase locked loop sensitivity:...
Page 30
Ucr100 lectrosonics, inc. 10 service and repair if your system malfunctions, you should attempt to correct or isolate the trouble before concluding that the equipment needs repair. Make sure you have followed the setup procedure and operating instructions. Check the interconnect- ing cables and then...
Page 31
Compact receiver rio rancho, nm 11.
Page 32: Limited One Year Warranty
Ucr100man.Indd 5 april 2011 581 laser road ne • rio rancho, nm 87124 usa • www.Lectrosonics.Com (505) 892-4501 • (800) 821-1121 • fax (505) 892-6243 • sales@lectrosonics.Com limited one year warranty the equipment is warranted for one year from date of purchase against defects in materials or workma...