Led Lenser F1R Operating Instructions Manual - page 17
Led Lenser®
*
EN Operating instructions F1R_V.01 | 7/31/2014
17
5. Operation
5.8 Attaching the Wrist Strap
To attach the enclosed wrist strap to the end cap:
1. Push the thin loop ① of the wrist strap from the inside,
through the attachment opening ③ of the end cap of the
flashlight.
2. Push the thick loop ② through the thin loop ① and pull
the thick loop ② until the thin loop ① has tightened about
the attachment opening ③.
5.9 Automated Functions
5.9.1 Temperature Monitoring
The F1R is fitted with a temperature monitoring function
(electronic regulation with temperature sensor). This prevents
the flashlight from overheating when in use. This may result in
a reduction in brightness as soon as the function is activated.
→
If necessary, switch off the flashlight and allow to
cool down.
5.9.2 Battery State Warning
A low charge state of the battery pack is signalized by 3 brief
flashes of the LED. The flashing is repeated every 15 seconds
until the flashlight switches itself off automatically after 10
minutes.
→
Remove the battery pack as described in chapters 5.4
and 5.5, charge and replace.
5.10 Cleaning
The following should be noted for cleaning:
•
Only dry clean the flashlight and its accessories using a lint-
free cloth.
•
If the flashlight comes into contact with salt water, remove
the salt water immediately and fully with a lint-free cloth.
ATTENTION
DAMAGE TO SURFACES
Solvents can damage surfaces or decompose
materials!
Therefore:
•
Do not use any cleaning agents or disinfectants.
•
Do not use scouring agents.
•
Do not use gasoline, paint thinners or similar
products.
1
2
3