Ledj Event Panel User Manual - page 4
LEDJ Event Panel
Over view
Over view:
Operation:
After the unit is powered up, Press the
“MODE” button to activate the main menu:
Built-in programmes, Auto run, DMX, Slave or Sound active mode.
“SETUP” button is to change the current mode.
“UP” button is to increase the value of the current setting.
“DOWN” button is to decrease the value of the current setting.
Built-in programmes: Runs one of the 12 built-in programmes.
Auto run: Runs the built-in programmes in a continuous loop.
DMX mode: The unit can becontrolled by any universal DMX controller.
Slave mode: The units in this mode can be synchronously run with a Event Panel
set to master mode.
Sound activated mode: Runs via sound activation using the built-in microphone
Built-in programmes mode:
With the LEDJ Event Panel, you can select 12 different Programmes. Press the
“SETUP” and
“UP” and “DOWN” buttons to select the programmes (from PG01 to PG12) and select the desired
programme value. When the LED display shows
PG.01
, press the
“SETUP” button for the
first time, and it will show
CL0.0
you can now select one of the 7 static colours by using the
“UP” and “DOWN” buttons; then press the “SETUP” button for the second time, and it will show
FS.00
, you can now select your desired flash frequency by using the
“UP” and “DOWN”
buttons. When in
PG.11
and
PG.12
, press the
“SETUP” button for a third and fourth time, and
it will show
C1.-1
, or
C2.-2
and now you can choose two colours for the programmes to work
in, using the
“UP” and “DOWN” buttons.
When in programmes
PG.02
-
PG.10
, press the
“SETUP” button for the first time, and it will
show
SP.99
, you can now set the running speed for this programme. Then press the
“SETUP”
button for a second time, and it will show
FS.00
, you can now select the flash frequency for it
using the
“UP” and “DOWN” buttons.
SP: Speed 00-99 (00 = slow, 99 = fast)
FS: Flash frequency from 00-99 (00 = slow, 99 = fast)
3