Ledj Event Panel User Manual - page 7

Operation For Battery Pack

1, Press the Transmitting mode button for more than 3 seconds, until the transmitting signal light is 

“ON”, then it means this unit is transmitting. If you want this unit to be the receiver, then you can 

    press the Receiving mode button for more than 3 seconds until the receiving signal light is 

“ON”. 

2, The UP and DOWN buttons are for selecting different channel frequencies of the

    battery pack. 

    For example, if you have 10 transmitters and 10 receivers, you can press the 

UP and DOWN 

    buttons to set their channel frequency accordingly. There are 125 to choose from.

3, When you are charging the battery pack the “Charging LED” will illuminate Red and once 

    the battery pack is fully charged, the 

“Charging signal light” will turn Green and the LED Event 

    Panel is now ready for use.

Note:

1, When using the battery to power the event panel, do not connect the 110V-240V power cable

2, When the battery is fully charged, it can supply a single colour on full output on the 

    LED Event Panel for about eight hours. 

3, Please make sure you connect all necessary cables before operation. 

4, Please recharge it immediately after discharge. 

 LEDJ Event Panel   

                          Operation For Battery Pack

6