Ledj Intense 9HEX10 User manual - Operating Instructions
www.prolight.co.uk
Intense 9HEX10 LED Slim Par User Manual
8
Built-in program mode:
To access the built-in program mode press “MODE” until the display shows
Pr.01
on the LED display.
Use the “UP” and “DOWN” buttons to select a program from
Pr.01
~
Pr.06
.
Press the “ENTER” button to confirm the setting.
To change the speed of the selected program press the “ENTER” button and then use the “UP” and
“DOWN” buttons to select any value from
SP00
~
SP99
. Press the “ENTER” button to confirm the
setting, then use the “UP” and “DOWN” buttons to select and value from
F500
~
F599
for the
strobe feature. Press the “ENTER” button to confirm the setting.
In
Pr.01
you are able to set a specific static colour. When in
Pr.01
press the “ENTER” button and
then use the “UP” and “DOWN” buttons to go through the static colours. Press the “ENTER” button to
confirm the setting, then use the “UP” and “DOWN” buttons to select and value from
F500
~
F599
for the strobe feature. Press the “ENTER” button to confirm the setting.
To exit out of any of the above options, press the “MODE” button.
Static colour mode:
To access the static colour mode press “ENTER” until
Colr
shows on the LED display.
Press the “ENTER” button and the LED display will show
r.225
. Now use the “UP” and “DOWN”
buttons to select the brightness between
r.000
~
r.255
. Press the “ENTER” button and repeat for
green, blue, white, amber and UV.
Value: 000 - 255 (000 = low, 255 = high)
To exit out of any of the above options, press the “MODE” button.
Master/slave mode:
To set the master unit, press the “MODE” button on the rear of the master unit then select your
desired program (sound active, auto, static colour or one of the built-in programs).
To set the other units in slave mode, press the “MODE” button on the rear of the unit to show
SLAU
on the LED display and press the “ENTER” button to confirm the setting. The units will now run in
sequence with the master unit.
To exit out of any of the above options, press the “MODE” button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.
Operating instructions
Pr.01
Static colour
Pr.02
6 colour fade
Pr.03
Multicolour fade
Pr.04
Multicolour illusion
Pr.05
6 colour change
Pr.06
Multicolour change
1.--r
- Red
2.--g
- Green
3.--b
- Blue
4.--u
- White
5.--A
- Amber
6.--I
- UV
7.-rg
- Orange
8.-rg
- Green/Yellow
9..-rb
- Bright Pink
10.rb
- Rose Pink
11.gb
- Light Blue
12.ru
- Salmon Pink
13.gu
- Pastel Green
14.bu
- Pastel Blue
15.uu
- Warm White
16.cu
- Full on (White)
Programs:
Static colours: