Ledj Intense 9HEX10 User manual - Operating Instructions
www.prolight.co.uk
Intense 9HEX10 LED Slim Par User Manual
9
Sound active mode:
To access the sound active mode, press the “MODE” button on the rear of the unit to show
SU00
on the LED display. Now press the “ENTER” button and use the “UP” and “DOWN” buttons to set the
sound sensitivity level from
SU.00
~
SU.31
and press the “ENTER” button to confirm the setting.
Value: 00 - 31 (00 = low, 99 = high)
To exit out of any of the above options, press the “MODE” button.
Auto mode:
To access the auto mode press “ENTER” until the display shows
Auto
on the LED display.
The fixture will now run through its built in programs. NOTE: The user can set up the speed and flash
speed for
Pr.02
~
Pr.06
under the built in programs mode. Changing this here will then take effect
when running auto mode.
To exit out of any of the above options, press the “MODE” button.
NOTE:
This fixture has a thermal protection function. The fixture will automatically enter into a self-protection
state and the LED display will flash “
-rt-
” if the thermal protection is activated. Switch off the
fixture and leave to cool down. Should the problem reoccur please contact your local dealer for
service and support.
Operating instructions
Built-in program
Pr.01
Static colour
Pr.02
6 colour fade
Pr.03
Multicolour fade
Pr.04
Multicolour illusion
Pr.05
6 colour change
Pr.06
Multicolour change
SP00
~SP99 (speed)
F500
~F599 (flash)
Static colour mode
r.000
~r.255 R
g.000
~g.255 G
b.000
~b.255 B
u.000
~u.255 W
A.000
~A.255 A
I.000
~I.255 UV
Auto mode
AUTO
Slave mode
SLAV
Sound active mode
SU00
~SU31
DMX mode
2CH, 3CH, 3CH, 4CH, 4CH,
5CH, 6CH, 8CH, 10CH
Address setting
A001
~A512
Menu system