Ledj LEDJ96 User manual - page 5
4
LEDJ RGBA Spectra Batten
Operation
Operation modes
Sound Active mode:
To activate the unit in sound active mode, press the
“MODE” button to show “SOUND MODE”
on the LCD screen. Now press the
“ENTER” button to select the desired sensitivity level by using
the
“UP” and “DOWN” buttons. Press the “ENTER” button again to select the frequency number
and adjust by using the
“UP” and “DOWN” buttons.
“SENS” 00 - 31 (00 = low, 31 = high), “FQN” 01-99 (01 = low, 99 = high)
Auto run mode:
To activate the unit in auto run mode, press the
“MODE” button to show “AUTO RUN” on the
LCD screen. Now press the
“ENTER” button to select the desired frequency number by using the
“UP” and “DOWN” buttons.
“FQN” 01-99 (01 = low, 99 = high)
Note: When the RGBA batten is set to
“SOUND” or “AUTO RUN” mode it will scroll through all
of its built-in programmes one after the other. The term
“FQN” refers to the number of times it
displays the buit-in programmes: for example if you set the
“FQN” to 3, it will then repeat each
programme 3 times before going on to the next one.
Slave mode:
To activate the unit in slave mode, first you must link multiple units together and press the
“MODE” button to show “SLAVE MODE” on the LCD screen. Now on the master unit press the
“MODE” button to select the desired mode and the slave units will now run in sequence with the
master unit.
Built-in programmes:
To activate the units built-in programmes, press the
“MODE” button to show “01.STATIC” on the
LCD screen. Press the
“ENTER” button to choose between the 13 built-in programmes by
using the
“UP” and “DOWN” buttons. Now press the “ENTER” button to select the desired speed
and adjust by using the
“UP” and “DOWN” buttons. Press the “ENTER” button once more to
select the desired flash value and adjust by using the
“UP” and “DOWN” buttons.
Speed values: 00 - 99 (00 = slow, 99 = fast),Flash values: 00 - 99 (00 = slow, 99 = fast)
For the 13 built-in programmes please see page 5.
DMX mode:
To activate the unit in DMX mode, press the
“MODE” button to show “DMX MODE” on the LCD
screen. Press the
“ENTER” button and select the desired DMX address setting by using the “UP”
and
“DOWN” buttons. Then to select one of the 6 DMX modes 2, 3, 4, 6, 7 or 19 channel,
press the
“ENTER” button again to choose the desired DMX mode by using the “UP” and
“DOWN” buttons.
For the 2, 3, 4, 6, 7 or 19 channel DMX address information please see pages 7 and 8.
NOTE: Once the desired settings have been selected in all of the modes,
ALWAYS
confirm the settings by pressing the
“ENTER” button.