Ledj Razor Beam User Manual - Operating Instructions
www.prolight.co.uk
Razor Beam User Manual
8
Built-in program mode:
To access the built-in program mode, press the “MODE” button on the rear of the unit to show
Pr.__
is displayed (the default is
Pr01
). There are 10 available programs, each has a unique sentence
of lighting fades and chases. Use the “UP” and “DOWN” buttons to select
Pr.01
through
Pr.10
.
Whilst using this program press the “SETUP” button, the display will now show
SP.__
. Use the “UP”
and “DOWN” buttons to select any numerical value from 00 to 99 to adjust the speed of the program
(99 being the fastest). To strobe the LEDs press the “SETUP” button, the display will read F5.00. Use
the “UP” and “DOWN” buttons to adjust the units strobe settings. F5.00 is full (on), F5.01 to F5.99 will
adjust the speed of the strobe (F5.99 being the fastest).
Auto run mode:
To access the auto run mode press “MODE” until the display shows
AUTO
. The unit will then
automatically sequence through it’s ten available programs as described above.
Static mode:
To access the static colour mode press “MODE” until
GraY
shows on the LED display. In this mode all
five LEDs will be illuminated. With the display showing
GraY
press the “SETUP” button. The display
will show
C.___
. Use the “UP” and “DOWN” buttons to adjust the brightness of the LEDs. You are able
to adjust this from
C.000
(off) to full brightness
C.255
. To strobe the LEDs press the “SETUP” but-
ton, the display will read F5.00. Use the “UP” and “DOWN” buttons to adjust the units strobe settings.
F5.00 is full (on), F5.01 to F5.99 will adjust the speed of the strobe (F5.99 being the fastest).
Sound active mode:
To access the sound active mode press “MODE” until the display shows
Sund
. Press the “SETUP”
button for the unit to display
Su.__
. Use the “UP” and “DOWN” buttons to select the sensitivity
(01 being the least sensitive and 31 being the most sensitive).
Master/slave mode:
To access the master/slave mode press “MODE” until the display shows
Slav
. This ensures the unit
is in slave mode. In this mode all the internal programmig is disabled which allows for the unit to follow
the standard DMX-512 protocol. It may be controlled by abother identical light fixture or by a standard
DMX controller. Use the “UP” and “DOWN” buttons to select the sensitivity
(01 being the least sensitive and 31 being the most sensitive).
Restore factory settings:
To perform a factory reset make sure the unit is powered off. Simultaneously press the “MODE” and
“SETUP”. Whilst holding these buttons power the unit on. The unit display will flash
rset,
this will
restore the unit to its factory settings.
To exit out of any of the above options, press the “MODE” button.
Please ensure that all slave units are set to the same DMX channel mode as the master unit.