Ledj spectra flood 18T3 User Manual - page 5
Spectra Flood 18T3
Operation Modes
Operation modes
Colour mix mode:
To access the units colour mix mode, you must be in the built-in programmes mode, choose Pr01
and select option
“7” White (RGB). To adjust the brightness of the individual red, green and blue
LEDs, press the
“ENTER” button to scroll through the colours and use the “UP” and “DOWN”
buttons to adjust each colour from 000 to 255.
Example:
If you set r, G and B to 000, the Spectra Flood 18T3 will have no LEDs on (blackout).
If you set r to 255 and G and B to 000, the Spectra Flood 18T3 will be 100% Red.
Built-in programmes:
To activate the units built-in programmes, press the
“MODE” button to show “Pr01” on the LED
screen. Now use the
“UP” and “DOWN” buttons to scroll through the built-in programmes from
Pr01 to Pr10. Now tap the
“MODE” button to select the desired speed and adjust by using the
“UP” and “DOWN” buttons. Press the “MODE” button once more to select the desired flash value
and adjust by using the
“UP” and “DOWN” buttons.
Speed values: SP00 - SP99 (00 = slow, 99 = fast),
Flash values: FL00 - FL99 (00 = slow, 99 = fast)
In
“Pr01” you can set a specific static colour. When in P.01, Press the “Enter” button and use the
“UP” and “DOWN” buttons to scroll through the list of built-in static colours.
0 = White (RGB)
1 = Red
2 = Orange 3 = Light Yellow
4 = Green 5 = Cyan
6 = Blue
7 = Purple 8 = Pink
9 = Yellow 10, Cool white
11, Warm white
To add strobe Press the
“ENTER” button again and use the “UP” and “DOWN” buttons to set
strobe from FL00 to FL99. To confirm your setting press the
“ENTER” button.
Note: F.00 = slow, F.99 = fast.
Auto run mode
To activate the units auto run mode, press the
“MODE” button to show “AUTO”
on the LED screen. The unit will now run through its built-in programmes.
DMX Mode
To activate the units DMX mode, press the
“MODE” button to show “d001” on the LED screen and
use the
“UP” and “DOWN” buttons to set the first digit in the DMX address from 0 to 512.
To choose one of the 5 DMX channels, press the
“ENTER” button and use the “UP” and “DOWN”
buttons to scroll the through the 1, 3, 4, 5 and 6 channel options.
To confirm your choice, press the
“ENTER” button.
For DMX functions, please see the DMX charts below.
Master/salve mode:
To set the unit as the master, simply use any of the above modes on the unit.
To set the unit as a slave unit(s), press the
“MODE” button to show “SLAV” on the LED display.
The unit will follow in sequence with the master unit.
4.