Lee Dan enterview Installation Instructions Manual

Summary of enterview

  • Page 1

    Innovations in communications since 1955 tm enterview tm video intercom system installation instructions monitor button 4 inch flat braun tube handset contrast control brightness control stand by switch door release button power on led frame camera call buttons microphone vm-300/8t entrance panel le...

  • Page 2

    Equipment location and housing installation entrance camera panel (vm-300/4t) enclosure: a. The entrance panel must not be located in areas of extreme heat or cold where the operating temperature range of 0-50 c might be exceeded or where it will be subjected to moisture or adverse weather condition...

  • Page 3

    Figure 3 - ih-357 & ih-358 video monitor box adapter plate vm-104 system layout a. Maximum number of vm-104 monitors per pk-314a is 50 units. Only one pk-314a control unit used per system. B. Each additional 80 vm-104 monitors require a pk-311 control unit and ps-250 transformer. (see figure 8 for p...

  • Page 4

    Figure 4 wiring layout diagram f. Wire gauge sizes for common wires only are as follows: +, -, ct : minimum 18 gauge for up to 50 monitors. Minimum 16 gauge for up to 100 monitors. 1,2,3,4 : two twisted pair 22 gauge. Must be shielded pairs if not in metal conduit. Intercom communication common wire...

  • Page 7

    Wire connections and equipment installation check all wires for shorts to each other and for grounds. Connect all wires (except 117 vac connections to transformers) as shown in the connecting diagram fig. 5 and in accordance with the wiring instructions. Refer to fig. 6 for dual entrance wiring. Ent...

  • Page 10

    With continuous product improvement, sizes and other specifications are subject to change without notice. Printed in usa © 1997-2002 lee dan ® communications, distributed by: toll-free: 800-231-1414 phone: 631-231-1414 fax: 631-231-1498 www. Leedan.Com 155 adams avenue hauppauge, ny 11788-3699 figur...