Leetek LTK-P1200 User Manual - page 3
System Programming:
To enter programming mode, press the “SETUP” button and enter the password “3690” followed by
“enter”. If the password is accepted, the display will show “use * to scroll to menu options”.
(Use the “
∗∗∗∗ / Menu”
key to scroll through the different menu options or press “CANCEL” to exit the
system programming menu.)
1. Setting the “Out of Range” (for coasters only)
(Factory Default: OFF)
With this feature, the coasters will play a Beep- sound for 10minute when taken out of range
of the transmitter to inform the guest that they are out of range and will miss their page. The
Beep-sound will stop, when they return back within range.
Be sure that all coasters are returned before turning out of range on or off.
TURNING THE OUT OF RANGE ON
• Remove all the coasters from the charging unit or unplug the power supply that is
connected to the charging base
• At
the
“Out of Range” menu, press the “#/Select” key to turn the out of range ON.
• Press
the
“ENTER” key. After sending the signal, all the coasters will light up once to tell
you that they received the new code.
• Press
“CANCEL” key to exit the system programming menu.
To test the coasters with out of range on, unplug the power supply, that is connected to
the transmitter. After 45 – 50 seconds, all the coasters will play a Beep-sound since
they are not receiving a signal from the transmitter. Plug in the power supply back into
the transmitter. After a few seconds, all coasters will stop playing the Beep-sound.
Return all the coasters to the charging base or plug the power supply. The coasters are
ready to receive the page with the out of range feature turned on.
TURNING THE OUT OF RANGE OFF
• Remove all the coasters from the charging unit or unplug the power supply that is
connected to the charging base
• At
the
“Out of Range” menu, press “#/Select” key to turn the out of range OFF.
• Press
“ENTER” key. After sending the signal, all the coasters will light up once to tell you
that they received the new code.
• Press
“CANCEL” key to exit the system programming menu.
To test the coasters with out of range off, unplug the power supply, that is connected to the
transmitter. After 45 - 50 seconds, all the coasters should not play the Beep-sound since the
out of range were turned off. If all or some of the coasters are playing the Beep-sound,
repeat the procedure above. If none of the coasters are playing the Beep-sound, return all
the coasters to the charging base or plug the power supply. Plug the power supply of the
transmitter. The coasters are ready to receive the page with the out of range feature turned
off.