Legacy Stoves SF250 Tribute Installation And Operator's Manual

Manual is about: COAL STOVE

Summary of SF250 Tribute

  • Page 1

    Installation and operator’s manual c c c co o o oa a a al ll l sssst t t to o o ov v v ve e e e m m m mo oo od dd deeeellll:::: ssssf ff f222255550000 t t t trrrriiiibbbbu uu utttteeee if this legacy stoves tm product is not installed correctly, a house fire may result. For your safety, follow insta...

  • Page 3

    Label placeholder -3-.

  • Page 4: Table Of Contents

    Table of contents introduction..............................................................................................................................................................5 safety considerations............................................................................................

  • Page 5: Introduction

    Introduction ank you for purchasing a legacy stoves tm coal stove. Whether you’re heating a room or heating your whole house, you’ve made the right choice. Please read this entire instruction manual before a,empting to install or operate your new stove. If you have further questions regarding your n...

  • Page 6

    Additional warnings and notices carbon monoxide (co) awareness carbon monoxide, referred to as co, is a colorless, odorless gas that is produced during combustion of coal and other fuels. Co fumes are toxic and can be fatal. E tlc 2000 is a natural draft system which relies on a properly designed ch...

  • Page 7: Installation

    Installation blower e blower slides into the channel bracket on the rear of the stove as shown at right. Plug the blower into a properly grounded receptacle. Shaker handle e shaker handle installs onto the shaker handle mount using the two hex-bolts and washers provided. Firebricks e sf250 tribute u...

  • Page 8

    Locating the stove locate the stove as close to the chimney or still maintaining the clearances to combustibles. Locate the stove where there is suncient air supply for ventilation and proper combustion. Clearance to combustibles safe stove clearance to combustible walls is 24” to the rear and 36” t...

  • Page 9: Chimney & Venting

    Chimney & venting types of chimneys e chimney is one of the most important, yet most neglected and misunderstood portions of any solid fuel burning stove installation. Do not connect this stove to a chimney another heating device. Chimney connectors shall not pass through an a,ic or roof space, clos...

  • Page 10

    N n n no o o ot t t te e e e:::: all horizontal runs of venting must have a 1/4 inch of rise per foot (or greater) of length. Use no more than two 90° elbows in the connector. If a barometric damper is needed, to compensate for excessive draft, install it only in a vertical section of vent pipe. Com...

  • Page 11

    Magnafire chimney specifics a) flue connecting pipe must not be less than 6 inches in diameter and of 24 gauge or heavier. B) connecting pipe joints are to be secured with screws (preferred) or pop rivets. Suggested location for fasteners is at the 12/4/8 o’clock positions. Refractory cement may be ...

  • Page 12

    E) manufactured chimney connections - when venting using a prefabricated chimney, be sure to contact local building code authorities, and to follow the manufacturer’s instructions exactly. Your manufactured chimney may contain more parts than is shown at right. Include all required items in your ins...

  • Page 13: Operating Instructions

    Operating instructions e sf250 tribute is approved for use with coal only. Burning wood or other such fuels in this stove, except for the purpose of igniting a coal 3re, is prohibited. Follow these steps to ensure safe and encient operation of your sf250 tribute. You will need to start a 3re in the ...

  • Page 14

    Ashes e ashes should never be allowed to accumulate in the ash pan. Excess ash will block the required aircause them to warp and sag. Is type of neglect is not covered by your stove’s warranty. Ashes should be placed in a metal container with a tight 3,ing lid. Is closed container of ashes should be...

  • Page 15

    Controlled firing also key to operational safety is avoiding over3ring the stove. Is stove features a manually set air intake damper, mounted on the ash door. Is consists of a cast, threaded dial, which when turned, allows for adjusting an air gap between the dial and the ash door. Once a 3re is est...

  • Page 16: Maintenance

    Maintenance periodic and normal everyday maintenance b b b blllloooow w w weeeerrrr m m m mo oo ottttoooorrrr:::: monthly, remove the blower and clean the fan. If there are pets in your house, you may want to check this more frequently. G g g grrrraaaatttteeeessss:::: maintain ash pan by emptying tw...

  • Page 17

    Glass maintenance air washing over the glass in the load doors is generally suncient to clean them, allowing for an unobstructed view of the 3re. Should it be necessary to clean the glass, allow the 3re to go out and clean the glass after it has cooled. Use a soft rag, dampened with a mild detergent...

  • Page 18

    Optional bent hot water coil optional bent hot water coil use a hole saw and the template supplied with the coil to make two holes through the side wall of the stove. Keep the coil holes above the 3rebrick and away from the loading door. Place one of the supplied nuts on each leg of the coil. Place ...

  • Page 19: Water Coil Option

    Water coil option example 2: circulating pump method. Used when the distance is more than ten feet or when the stove is on a higher level than the existing water heater. In addition to a circulator, you may want to add a aquastat to control the pump according to water temperature. Is is not necessar...

  • Page 21

    -21- description u/m part number door latch ea 1-00-00036a sf250 heat collector assembly ea 1-00-00828 brick set sf250 (14) set of 14 1-00-08136 17-1/2in flapper-sf250,260,360 ea 1-10-00407 250 brick retainer ea 1-10-00409 long shaker handle weldment ea 1-10-01005a firebox reducer- 15in sf260/36 ea ...

  • Page 22: Alternate Heating Systems

    Warranty information (2 pages) alternate heating systems lifetime limited warranty alternate heating systems, on behalf of its hearth brands (”ahs”), extends the following warranty for legacy stoves tm wood and/or coal hearth appliances that are purchased from an ahs legacy stoves authorized dealer....

  • Page 23

    Warranty conditions: • this warranty only covers ahs appliances that are purchased through an ahs legacy stoves authorized dealer or distributor. A list of ahs legacy stoves authorized dealers is available on the ahs legacy stoves branded websites. • this warranty is only valid while the ahs applian...

  • Page 24

    Service and maintenance log date of service performed by description of service.

  • Page 25

    Date of service performed by description of service -25-.

  • Page 26

    Advanced design old fashioned values (signature of boxer) your premium quality hearth product designed and assembled by the experienced and skilled members at alternate heating systems in harrisonville, pa, usa..