Legend 738BXN (NG) Installation & Operating Instructions Manual - page 20
Bottom
of window
(wider frame)
Warranty
Card at the
back of this
manual.
Read the Safety
Information
section on page 4
of this manual.
Operating Your
Fireplace
For your safety, this appliance is fitted with a flame
supervision device which will shut-off the gas supply
if, for any reason, the pilot flame goes out. This device
incorporates a fixed probe, which senses the heat
from the pilot flame. If the probe is cool, the device will
prevent any gas flow unless manually lighting the pilot.
See full lighting instructions on page 24 of this manual.
Cleaning
Important - Glass cleaning - Mineral deposits
One of the by-products of the combustion process in
a gas appliance is a mineral which can show up as a
white film on the ceramic glass of the viewing door.
The composition of the deposit varies widely from
various locations and also from time to time in the
same location. It seems this is associated with the
varying sulfur content of the gas. You may have the
problem for a time and then not see it for many months
when it will reappear in your area.
We have discussed this problem with ceramic glass
manufacturers and they cannot give us a definitive
answer to this problem. Dealers have tried various
cleaning products with varying results. The following
recommendations will not guarantee results in your
particular case.
Owner’s Information
Performance of LPG appliances may be affected by
the quality of commercial gas supplied in your area.
NOTE: This is a problem beyond Miles Industries’
control and is not covered under warranty.
• Clean the glass regularly as soon as you notice
the buildup (white film). If the film is left for a longer
period of time, it will bake on. It is then much harder,
if not impossible, to remove.
• NEVER use an abrasive cleaner on the ceramic
glass. Any abrasion of the surface has the
immediate effect of compromising the strength of the
glass. An emulsion type cleaner is recommended.
• Use a soft damp cloth to apply the cleaner. Dry the
glass with a soft, dry, preferably cotton cloth. Most
paper towels and synthetic materials are abrasive to
ceramic glass and should be avoided.
• Our dealers have had good results from the
products listed below. We cannot, however,
guarantee the results of these products.
»
»
B
rasso
,»P
olish
»P
lus
»by»K
elKem
,»C
ooK
»T
oP
»C
lean
»
C
reme
»by»e
lCo
,»W
hiTe
»o
ff
»by»r
uTland
,»T
urTle
»W
ax
Do not clean the glass while it is hot. Always
securely replace the
window before lighting.
If
broken, the glass pane
may only be replaced
as a complete window
unit as supplied by the
manufacturer.
To remove the window for
cleaning:
1. Turn each bolt a quarter
turn to disengage the bolt
pin.
2. Gently pull the bottom
of the window outward
and unhook it from the
firebox’s opening frame.
3. Set the window aside
in a safe place to avoid
damage.
To refit the window:
1. Hook its top part to the firebox’s opening frame.
Make sure that the wider part of the window
frame is at the bottom.
2. While you hold the window, push in and turn the
two top spring-loaded bolts a quarter turn to engage
their pin.
3. Push in the bottom of the window against the firebox
and fasten the two bottom spring-loaded bolts a
quarter turn.
WARNING
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the fireplace cool first before cleaning it.
CAUTION
Your fireplace becomes very hot when operating.
Avoid placing decorating objects sensitive to heat
within 36 inches (0.9 m) around it.
Do not put
furniture or other objects
in this space in front of
the fireplace:
36” (0.9 m)
Fireplace
Hearth
20