Legend 739ILN Owner's Manual - page 21
OWNER’S INFO
Bottom
of window
(wider frame)
To refi t the window:
1. To refi t the window,
hook its top part to
the fi rebox’s opening
frame. Make sure
that the wider part
of the window
frame is at the
bottom.
2. While you hold it,
push in and turn
the two top spring-
loaded bolts a quarter turn to engage their pin.
3. Push in the bottom of the window against the fi rebox
and fasten the two bottom spring-loaded bolts a
quarter turn.
4. Then, pull out the top and bottom of the window and
release it to insure the springs return it.
5. Apply light hand pressure against the window frame
sides to bed-in the window seal.
Soot or dust can be brushed from the ceramic logs
and fi rebox walls using a soft brush. Dust can also
be removed from the burner using a soft brush after
removing the ceramic logs. When cleaning, make sure
that no particles are brushed into the slots of the burner.
Checks
A periodic check of the pilot and burner fl ames should
be made. Check after the fi re has been on for at least
30 minutes. The pilot fl ame must cover the tip of the
thermocouple probe. The main burner fl ame pattern will
vary from appliance to appliance depending on the type
of installation and climatic conditions.
Correct Flame Picture
Pilot Flame
can be seen
between
logs
Owner’s Information
Pilot
Flame
The appliance area must always be kept clear and
free from combustible materials, gasoline and other
fl ammable vapors and liquids.
Inspect the vent terminal outdoors regularly to make
sure that snow, trees, bushes, leaves, or other objects
do not obstruct it.
Examine the vent system and terminal regularly. We
recommend annually.
Batteries
Low battery signal: see page 26.
BEFORE changing the batteries, turn off the valve
using the manual On/Off switch —
see instructions
next page.
The appliance uses four 1.5 V AA alkaline batteries
for its remote control receiver and one 9 V alkaline
battery for its handset. Batteries should last one to two
seasons, depending on usage. Removing the batteries
in the off-season will extend the battery life. Should the
batteries loose power, the control may be operated by
manually turning the control knob at the valve or by
turning off the valve at the switch.
To replace the batteries in the remote control
receiver
:
1. The receiver is located to the left of the valve and it
is retained to the fi rebox by a Velcro tab. Grab the
receiver and pull it out from its location.
2. Slide and remove the receiver cover.
3. Replace the 4 AA batteries.
4. Replace the cover.
5. Put the receiver back in its position pushing it in so
it attaches to the Velcro tab.
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
WARNING
DO NOT ATTEMPT TO CHANGE THE BATTER-
IES WHILE THE FIREPLACE IS STILL HOT!
Let
the fi replace cool fi rst before touching it.
21